Seville Classics airLIFT OFF65869 User manual

Thank you for choosing Seville Classics! We hope that you enjoy your new sit-to-stand
Model #: OFF65869
AIRLIFT® Corner Standing Desk Converter
6-20186-2018

Parts List
A. AIRLIFT® Desk (1)
C. Tray (1)
D. Zip-Ties (2)
E. Allen Wrench (1)
F. Wire Clip (4)
G. Screws (6)
B. Brackets (2)
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at [phone] or send an email to
[email protected]
Telephone : [phone]
Fax : [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email:[email protected]
Homepage : www.SevilleClassics.com
Dimensions: 43.31" W x 23.62" D x (5.9" to 19.7") H
Maximum weight on tray: 5 lbs. (2 kgs)
Maximum weight capacity overall: 33 lbs. (15 kgs)
FAQS
A. Yes! Be sure the desk is below it’s 33 lbs. maximum weight limit.
Q. What size is the base?
A. Base measures 32.75 inches wide and 22 inches deep.
Q. Do I need to plug it in?
2. Pull up on both AIRLIFT® levers and press down on desktop to lower.
Required Tools (not included)
Screwdriver Scissors
1 6

STEP 1.Remove AIRLIFT® DESK (A) from box and set on flat table. Weighs 52.3 lbs.
STEP 3.
Flip TRAY (C) upside down.
BRACKETS (B)to underside of TRAY (C)with
SCREWS (G) and screwdriver.
Safety
DO NOT place devices on desk edge.
DO NOT
DO NOT route wires through desk legs.
MAKE SUREdevices have cables long enough for
the full-range (15 in/38 cm) of height-adjustment.
Requires 2
personal injury
2
5
STEP 2.
the AIRLIFT® DESK (A).
E

STEP 5. Pull up on both
STEP 4. Hook BRACKETS (B) over the bolts on the inner legs of the AIRLIFT DESK (A).
Tighten bolts clockwise with included ALLEN WRENCH (E).
STEP 6. Place your belongings on the desktop to finish!
Organize loose cables with included ZIP TIES (D).
ALWAYS route your cables through the REAR of the desk.
NEVER route cables through the legs of the desk.
Cable Management
WIRE CLIPS (F)to back of the crossbar.
Use these clips to route cables from keyboards, mice and monitors through the REAR of the desk.
3 4
Warning: Impact Hazard! Moving
Parts can Crush and Cut.
®
AIRLIFT DESK (A)®
D