Seville Classics 15896 User manual

#15896
2-TIER UTILITY SHOE/STORAGE RACK
ASSEMBLY INSTRUCTIONS
CUSTOMER SERVICE
Tel [phone]
Tel [phone]
Fax [phone]
Email: [email protected]
Monday through Friday
8:30 am - 4:30 pm (Pacic Time)
Please Read and Save These Instructions
US & International Patents Pending ©2014 Seville Classics, Inc.
Seville Classics, Inc.
Torrance, CA 90501 USA
www.sevilleclassics.com

A B C D E
Side Frame (x2) Leveling Foot (x4) Cap (x4)
(Pre-installed)
Shelf (x2) Stacking Pin (x4)
STEPS TO ASSEMBLE THE RACK
1. Unpack and remove all parts from the box.
If there are missing or broken parts, please
contact our CUSTOMER SERVICE.
2. Screw the LEVELING FEET (B) into the legs of
each SIDE FRAME (A).
3. Insert the hooks on both sides of the SHELF
(D) into the lower brackets of the side frames.
4. Repeat step 3 for the second shelf.
5. Once all shelves are securely in place, adjust
the leveling feet by screwing them in or out to
obtain a level rack.
WARNING: Do not sit on the rack. Do not drop heavy items on
the rack. Place heavier items on the lower shelves and lighter
ones on the top shelves. Do not move the rack while loaded. Do
not move the rack by lifting the shelf, use the tops of the side
frames instead.
WEIGHT CAPACITY: 25 lb per shelf
CUSTOMER SERVICE
Tel [phone]
Monday through Friday
8:30am - 4:30pm (P Time)
www.sevilleclassics.com
Made in China SL141022
STEPS TO
1. Build another rack following the
instructions on the left. However, do not
install the LEVELING FEET (B) on the second
(top) unit.
2. Screw the STACKING PINS (E) into the legs of
the top unit. Remove all CAPS (C) from the
original (bottom) unit.
3. Lift the top unit up, lining up the pins with
the holes at the four top corners so that the
pins can be inserted into them. Be sure
everything is in alignment and then press the
top unit do o
the bottom unit.
STACK THE RACK
NOTE: Drawing shows 2 units
stacked vertically. Do not exceed
maximum height of 2 stacked units.