Seville Classics OFF65807 User manual

Thank you for choosing Seville Classics! We hope that you enjoy your new sit-to-stand
desk. Please read through this user guide for parts list, instrucons, frequently asked
quesons and contact informaon.
Model #: OFF65807, OFF65808
AIRLIFT™ Pneumac Sit-to-Stand
Adjustable Desktop Converter
09-201709-2017

Parts List
A. AIRLIFT™ Desk (1)
C. Tray (1)
D. Zip-es (2)
E. Allen wrench (1)
F. Wire clip (1)
G. Screws (6)
B. Brackets (2)
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at [phone] or send an email to
[email protected]
Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: [email protected]
Homepage: www.SevilleClassics.com
Specicaons
Dimensions: 35.43" W x 23.23" D x (5.9" to 19.7") H
Maximum weight on tray: 5 lbs. (2 kgs)
Maximum weight capacity overall: 33 lbs. (15 kgs)
FAQS
Q. Can I aach a monitor stand to it? What about dual monitors?
A. Yes! Be sure the desk is below it’s 33 lbs. maximum weight limit.
Q. What size is the base?
A. Base measures 32.75 inches wide and 22 inches deep.
Q. Do I need to plug it in?
A. Nope! It’s fully pneumac. Just put it on the table and get started!
Use Instrucons
1. Pull up on both AIRLIFT™ levers and desktop to li.
2. Pull up on both AIRLIFT™ levers and press down on desktop to lower.
Required Tools (not included)
Screwdriver Scissors
16

Assembly Instrucons
STEP 1. Remove AIRLIFT™ DESK (A) from box and set on at table. Weighs 52.3 lbs.
STEP 2.
Cut the plasc es on
both sides of the
AIRLIFT™ DESK (A).
STEP 3.
Flip TRAY (C) upside down. Aach
BRACKETS (B) to underside of TRAY (C)
with SCREWS (G) and screwdriver.
Safety
DO NOT place devices on desk edge.
DO NOT quickly li desktop when loaded.
DO NOT route wires through desk legs.
MAKE SURE devices have cables long enough for
the full-range (15 in/38 cm) of height-adjustment.
Requires 2
people to li
Failure to follow these instrucons may result in property damage or
personal injury
2
5

STEP 5. Pull up on both AIRLIFT™ levers and desktop to li.
STEP 4. Hook BRACKETS (B) over the bolts on the inner legs of the AIRLIFT™ DESK (A).
Tighten bolts clockwise with included ALLEN WRENCH (E).
STEP 6. Place your belongings on the desktop to nish!
Organize loose cables with included ZIP TIES (D).
ALWAYS route your cables through the REAR of the desk.
NEVER route cables through the legs of the desk.
Cable Management
WARNING: DO NOT PLACE HANDS ON
DESK LEGS. MOVING PARTS CAN CRUSH. Sck the WIRE CLIP (F) to back of the crossbar. Use this clip to route cables from keyboards, mice and
monitors through the REAR of the desk.
34