Seville Classics UltraHD UltraGuard 20230 User manual

SC221012
ASSEMBLY INSTRUCTIONS
UltraHD® Wall Cabinet with Open Shelf
(Model No. 20230, 20140, 20150, 20130)
36 in. W X 12 in. D X 30 in. H
(91.44 cm W X 30.48 cm D X 76.2 cm H)
Granite Graphite Red White
Reference page 10 for special care and
maintenance of stainless steel

#6
#11
#59
#41
#8
#55
#7
#3
#1
#15
#9
#10 #2#34#4
#5
#23
1

Please check the parts carefully according to the parts list. If you are missing any parts, please contact our
service department. (Please refer to page 11).
(#3) TOP PANEL x 1 PC
(#4) MIDDLE LAYER PANEL x 1 PC
PARTS LIST
(#1) LEFT PANEL x 1 PC
(#2) RIGHT PANEL x 1 PC
RECOMMENDED TOOL LIST
STUD FINDER
LEVEL
PART LIST
TRIANGULAR SQUARE
2

Please check the parts carefully according to the parts list. If you are missing any parts, please contact our
service department. (Please refer to page 11).
#34 HOOK x 4 PCS
PARTS LIST
(#11) WALL-HANGING BRACKET x 2 PCS
(#9) LEFT DOOR x 1 PC
(#10) RIGHT DOOR x 1 PC
(#7) UPPER BACK PANEL x 1 PC
(#8) BOTTOM BACK PANEL x 1 PC
(#5) BOTTOM PANEL x 1 PC
(#6) MIDDLE SHELF x 1 PC
3

Please check the parts carefully according to the parts list. If you are missing any parts, please contact our
service department. (Please refer to page 11).
PARTS LIST
(#41) SCREW F (M4 x 8L) x 44 PCS
(#55) SCREW M (M6 x 50L) x 12 PCS
(#59) PLASTIC ANCHOR x 12 PCS
(#15) SCREW B (M4 x 8L) x 6 PCS
(#21) SCREW DRIVER x 1 PC
(#22) KEY x 2 PCS
(#23) MAGNET x 2 PCS
4

TIP:
Step 1:
Note:
Step 2:
Step 3:
A magnetic screwdriver is included for your
convenience. If using a powered screwdriver,
keep torque setting on LOW.
Attach the Right Panel (#2) to the Top Panel (#3)
as the left picture shows. Line up screw holes and
tighten them using Screw Driver (#21) and 3 pcs of
Screw F (#41).
UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
*NOTE: We recommend using TWO people to assemble the cabinet.
Install the Middle Layer Panel (#4).
Attach the Middle Layer Shelf (#4) as the left
picture shows. Use 6 pcs of Screw F (#41) to
fasten the Middle Layer Panel to the Left and
Right Panel (#1 and #2).
Note: The outside edges of the panels should be
flush, creating a nice square frame.
Install the Left Panel (#1) onto the Top Panel (#3)
Install the Right Panel (#2) onto the Top Panel (#3)
Attach the Left Panel (#1) to the Top Panel (#3) as
the left picture shows. Line up screw holes and
tighten them using Screw Driver (#21) and 3 pcs of
Screw F (#41).
The outside edges of the panels should be flush,
creating a nice square frame.
Front
Back
5

Step 4:
Note:
Step 5:
Step 6:
Note:
UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
*NOTE: We recommend using TWO people to assemble the cabinet.
Attach the Bottom Panel (#5) as the left
picture shows. Use 6 pcs of Screw F (#41) to
fasten the Bottom Panel (#5) to the Left and
Right Panel (#1 and #2).
The outside edges of the panels should be
flush, creating a nice square frame.
Install Bottom Panel (#5).
Install the Bottom Back Panel (#8) and Upper
Back Panel (#7).
First place the Bottom Back Panel (#8) onto
the Left, Right and Bottom Panels (#1, #2 and
#5) as the left picture shows. Now place the
Upper Back Panel (#7) onto the Left, Right
and Top Panels (#1, #2 and #3). Line up screw
holes and tighten them using Screw Driver
(#21) and 22 pcs of Screw F (#41).
Fasten the Magnet (#23).
Fasten 2 pcs Magnets (#23) seperately to the
Top Panel (#3) and Middle Layer Panel (#4)
with 4 pcs of Screw F (#41).
The side with the pad on the magnet need to
face outward.
Check for SQUARENESS by
using a triangular square
before attaching Back Panels
#41
#5
6

Step 7:
Note:
Step 8:
Note:
Step 9:
Note:
Install the Left Door (#9)
The Middle Shelf (#6) needs 4 hooks at each
corner for support. When placing the hooks,
make sure they are at the same height.
b. Place the Middle Shelf (#6) into the cabinet
and push down onto the Hooks (#34).
Attach the Left Door (#9) on the Left Panel
(#1). Line up screw holes and tighten them
using Screw Driver (#21) and 3 pcs of Screw B
(#15).
UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
*NOTE: We recommend using TWO people to assemble the cabinet.
Install the Middle shelf (#6)
A. Decide the height for the Middle Shelf (#6),
place the Hooks (#34) into the hook slots and
push down.
The oval screw holes on the door hinge allow
for adjustment of the Door Panel.
Install the Right Door (#10)
Attach the Right Door (#10) on the Right
Panel (#2). Line up screw holes and tighten
them using Screw Driver (#21) and 3 pcs of
Screw B (#15).
The oval screw holes on the door hinge allow
for adjustment of the Door Panel.
7

*Drill a small hole (1/8" diameter) at stud locations to assure that the hanging anchor is secured.
Note: Use a stud finder and a level to ensure that holes are in the correct location.
The wall cabinet can also be mounted on a brick, masonry, or basement block wall using the correct concrete
wall anchors, and screw set. Each wall anchor must support up to 25 lbs loading capacity.
UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
*NOTE: We recommend using TWO people to assemble the cabinet.
To find the screw holes to fasten the
Wall-Hanging Brackets, please refer to
the accompanying shop drawing. Place
the shop drawing on the wall and align
the holes in the drawing.
Put 12 pcs green Plastic Anchor (#59) into the hole. Use 12 pcs of Screw M (#55) to fasten
Wall-Hanging Brackets (#11). Hang the unit on the Wall-Hanging Brackets (#11).
8

A. Decide where to hang the Wall Cabinet.
C. Locate the 2nd stud 16” from either side of the 1st stud location.
UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
*NOTE: We recommend using TWO people to assemble the cabinet.
B. Start from one side of desired location to find the 1st stud location for installing the Wall-Hanging Brackets (#11).
Use a stud finder and a level to locate the stud. Use a pencil to mark the CENTER of the stud.
Note: The distance between two studs is normally 16” (center to center). The average stud width is about 1.5" wide.
Back Panel View of Wall Cabinet shows 6 flat hooks that
allow the Cabinet to hang on two Wall hanging Brackets.
Close-up view of how the Wall-Hanging Brackets fit
with the 6 flat hooks on the back of the cabinet.
Note: We recommend that the cabinet be hung such that the bottom of the cabinet rests approx. 55.5" above the floor.
for UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
Installation Guide for the WALL HANGING BRACKET
Recommen
d Height
from Floor
55.5"
DOOR
FLOOR
9

UltraHD® Stainless Steel Care Instructions
• Lightly wipe with warm water and clean microfiber cloth
• Always wipe in the direction of the surface grain (NEVER ACROSS)
• Wipe away excess water with dry clean cloth
UltraHD® Wall Cabinet with Open Shelf (Model No. 20230, 20140, 20150)
*NOTE: We recommend using TWO people to assemble the cabinet.
The stainless-steel parts of this product are protected with an UltraGuard® fingerprint resistant finish.
DO NOT use traditional stainless-steel cleaners. To safely manage unwanted fingerprints and prevent new
stains, perform the following steps once monthly:
10

Seville Classics, Inc.
19401 Harborgate Way Torrance, CA 90501 USA
Telephone: [phone] within USA
Fax: [phone]
Hours: 9:00am - 4:30pm (Pacific Standard Time)
E-mail: [e-mail]
Website & Online Store: www.sevilleclassics.com
UltraHD® Tall Storage Cabinet UltraHD® Mega Storage Cabinet
Model No. 16236 (Granite) Model No. 16238 (Granite)
Model No. 20143 (Graphite) Model No. 20148 (Graphite)
Model No. 20153 (Red) Model No. 20158 (Red)
Model No. 20133 (White)
CONTACT INFORMATION
If you are missing any parts, have any questions, or need additional assistance in assembly, please contact our
bilingual (English and Spanish) customer service department at:
***Please visit our website or call and inquire about our additional UltraHD Line***
UltraHD® Line
11

UltraHD® 4-Drawer Rolling Cabinet UltraHD® 6-Foot Height Adjustable Workbench
Model No. 20205 (Granite) Model No. 20292 (Granite)
Model No. 20293 (Graphite)
UltraHD® Wall Cabinet with Open Shelf UltraHD® 2-Door Rolling Workbench
Model No. 20230 (Granite) Model No. 20262 (Granite)
Model No. 20140 (Graphite) Model No. 20142 (Graphite)
Model No. 20150 (Red) Model No. 20152 (Red)
UltraHD® Rolling Trash Bin UltraHD® Lighted Workcenter
Model No. 20215 Model No. 20247 (Granite)
Model No. 20246 (Graphite)
Model No. 20157 (Red)
UltraHD® Line