Seville Classics UltraHD Bench User manual

TR180110
ASSEMBLY INSTRUCTIONS
UltraHD Bench (Model No. 20272)
36 in W x 14 in D x 18.5 in H
(91.44 cm W x 35.56 cm D x 46.99 cm H)

(pg 1 of 6)

(#6) Leveling Feet x 4 PCS (#40) Screw E (M8 x 18) x 12 PCS
(#3) Solid Hardwood Top x 1 PC
PARTS LIST
(pg 2 of 6)
Please check the parts carefully according to the parts list. If you are missing any parts, please call our customer service department
(please refer to page 6 of 6).
(#5) Leg x 2 PCS
(#1) Wire Grid Shelf x 1 PC (#2) Top Crossbar x 2 PCS

(#25) Wrench x 1 PC
(#21) Screw Driver X 1 PC
PARTS LIST
(pg 3 of 6)
Please check the parts carefully according to the parts list. If you are missing any parts, please call our customer service
department (please refer to page 6 of 6).
(#14) Screw A (M4 x 10L) x 4 PCS
(#27-B) M8 Washer x 12 PCS

Step 1:
Note:
Step 2:
Note:
Step 3:
Note:
Assemble Top Crossbar (#2)
Assemble Leg (#5)
Do not fullly tighten the screws until
after Step 3.
Fasten all screws after this step.
Assemble Wire Grid Shelf (#1)
Attach the Wire Grid Shelf (#1) between the two
legs, make sure the shelf edge is align with the legs,
use 4 pcs Screw A (#14) to tighten the shelf onto the
legs.
Open the package, remove and place all parts to
the side. Then open the package of the Solid
Hardwood Top (#3).
Attach both Top crossbars (#2) to the Solid
Hardwood Top (#3). Use 4 pcs Screw E (#40) with
Washer (#27-B) and Wrench (#25) to tighten.
Do not fullly tighten the screws until
after Step 3.
ASSEMBLY INSTRUCTIONS
(pg 4 of 6)
Bench (Model No. 20272)
Attach the Legs (#5) as the left photo shows, line up
screw holes, use 8 pcs Screw E (#40) and Washer
(#27-B) to tighten the leg.
The screw holes on the Leg (#5) is facing inside of
the bench
Screw Hole
Screw Hole