When you need an extra burst of steam to
clean tough, dried messes and stuck-on stains,
use the Steam Blaster.
1. Flip back the Intelli-Mop™ Head so that it is
behind the mop body.
2. Tilt the mop handle back. This will cause the
Steam Blaster to emit a concentrated blast
of steam onto the floor.
3.
To stop the Steam Blaster spray, simply tilt
the mop handle forward.
4. Flip the Intelli-Mop Head back into its
original position and continue cleaning.
2
3
4
1
INTELLI-MOP™ HEAD TECHNOLOGY
ABOVE-FLOOR CLEANING DIRT GRIP™ PADS
TOUCH-FREE PAD ATTACHMENT
2
3 4
DOUBLE-SIDED, WASHABLE, REUSABLE
Our washable Dir t Grip Pads are made with fibers specially designed to absorb and trap dirt.
This gives your floors an amazing clean, with minimal streaking and shor t dry times.
For best cleaning results, we recommend replacing your
Dirt Grip Pads following 20 normal uses.
PAD CARE
Machine wash the Dirt Grip Pads separately with warm
water using liquid detergent.
NEVER USE BLEACH, POWDERED DETE RGENT,
OR FABRIC SOFTENERS as they may damage
the Dirt Grip Pads.
You can purchase replacement Dir t Grip Pads and
other accessories by visiting sharkaccessories.com
or calling 1-800-798-7398.
1
1
1. Lift the mop straight up by the handle
until the Intelli-Mop Head is hanging
straig ht down. Center the mop head
above the pad. Press down the release
buttons on the sides of the head post, and
both sides of the mop head will drop open.
1. Lift the mop straight up by the handle
until the Intelli-Mop Head is hanging
straig ht down. Press down the release
buttons on the sides of the head post, and
both sides of the mop head will drop open.
2. Slip the mop head’s 4 corner tabs into the
4 corner pockets of the Dirt Grip™ Pad.
3. Gently press the Intelli-Mop Head to the
floor on one side of the pad, and that side
will click into place.
4. Flip the other side of the Intelli-Mop Head
over onto the floor to click into place.
Remove the Handheld Steamer by pressing the release button and pulling it away from the cradle.
Note: In Handheld Mode, the STEAM CONTROL is preset to HI to optimize above-floor
cleaning and garment steaming.
Snap the desired accessory into the main nozzle of the Handheld Steamer. Then squeeze the
steam trigger to activate steam.
Using 3-to-5-second bursts of the trigger will allow you to steam longer and with more control.
CUSTOM CLEANING ACCESSORIES HOW TO ATTACH
ACCESSORY HOSE
For spot cleaning and direct steaming
Slide Accessory Hose onto the Handheld
Steamer.
GARMENT STEAMER
Freshen clothing, fabric s, and upholstery
Slide the Garment or Upholstery Bonnet onto
the Garment Steamer. Elastic will hold the
bonnet in place.
Snap the bristle over the Garment Steamer
and bonnet then click the Garment Steamer
onto the Handheld Steamer.
SMALL ABOVE-FLOOR POCKET TOOL WITH PAD
Ideal for small, uneven surfaces. The pointed tip is
great for edges and corners.
Slide the pad onto the Small Above-Floor
Pocket Tool so it fits snugly. Cinch the elastic
band and slide the locking toggle to tighten.
Connect the tool to the Accessory Hose by
pushing firmly until it clicks into place, then click
the Accessory Hose onto the Handheld Steamer.
Once done with handheld steaming, press the STEAM CONTROL button until the light flashes
blue to put the unit in STANDBY MODE. Let cool for 2 to 3 minutes before removing mop
head, pads, or handheld accessories and storing.
CAUTION: Make sure the Steam Mop is unplugged or in Standby Mode while attaching or
removing the accessories. Avoid touching the accessories, as they will be very hot after steaming.
It is recommended that you allow the pads to cool off before removing them from the
accessories to avoid possible scalding injury.
STEAM BLASTER™ TECHNOLOGY
TOUCH-FREE PAD REMOVAL
CLEANING
USING YOUR LIFT-AWAY® PRO STEAM POCKET®MOP
INTELLIGENT STEAM CONTROL®
With the Intelli-Mop™ Head, you can quickly and easily attach and release the Dirt Grip™
Pads without touching them. No more wrestling with dir ty, wet pads. The Dirt Grip Pads
are double sided, washable and reusable. For pad attachment and removal instructions
see the following page.
Your Lift-Away Pro Steam Pocket Mop is ideal for deep cleaning and
cutting through dirt and grime in high-traffic areas, as well as for
sanitizing* floors.
*Sanitization studies were conducted under controlled test conditions.
Household conditions and results may vary. With the Intelli-mop head only in
HI mode. Not in above-floor mode or when using Steam Blaster™. See Owner’s
Guide for instructions.
Plug the power cord into an outlet. The STEAM CONTROL button will flash blue.
Press the STEAM CONTROL button to
select your steam setting: once for LO,
twice for HI, and three times to place the
unit in STANDBY MODE.
SETTING
IDEAL FOR
THESE SEALED
SURFACES
RECOMMENDED
USAGE
Tools Laminate
Hardwood
Marble
Light cleaning and dusting
Loosening and lifting light dirt
Cleaning delicate surfaces
LO
Hardwood
Marble
Tile
Stone
Cleaning most surfaces and large areas
Basic, everyday cleaning
Removing spots and smaller messes
Cleaning moderate and heavy-traffic areas
HI Hardwood
Marble
Tile
Stone
Deep cleaning and cleaning hard-to-clean surfaces
Tough cleaning and removing stuck-on messes and stains
Deep cleaning heavy-traffic areas
Cutting through heavy dirt and grime
Sanitizing* floors
