SHEDorize Workbench with Pegboard and Accessories User manual

SHEDorize.com
[phone]
[e-mail]
contents
•2 - brackets
•12 - #10 3" white screws, #2 sq dr
•24 - #10 2.5" white screws, #2 sq dr
•6 - #8 1" black screws, #2 sq dr
•4 - #10 2" black screws, #2 sq dr
•2 - 24" x 48" pegboards
•1 - 24" x 48" bench
•1 - 2" x 3" x 48" long cross piece
•2 - long 2" x 3" corner braces (diagonal cut)
•Pegboard multi-use wire basket
•Pegboard garage/workshop kit
•Pegboard angle multi tool hang
•Magnetic parts jar 4 pack
SHEDorize Workbench with Pegboard and
Accessories (24" x 48")
Instruction Manual
happy with our products?
Please help us spread the
word by leaving a review at:
www.SHEDorize.com
Finished | Unfinished

SHEDorize.com
[phone]
[e-mail]
Setting Up Your SHEDorize Workbench with
Pegboard and Accessories (24" x 48")
CONFIRM THAT ALL PARTS ARE PRESENT BEFORE BEGINNING ASSEMBLY.
1. Assemble workbench, cross piece, and corner braces.
a. Put the bench on its side. Place the corner braces with the
diagonal cut underneath against the plywood in the front two
corners and fasten the short white screws in the pre-drilled
holes on the side of the bench.
b. Take the corner braces with the diagonal cut, and place on the
marks of the 48" cross piece. Fasten the short white screws in
the pre-drilled holes of the 48" cross piece.
2. Fasten steel brackets to bench.
a. Figure out how far apart the studs are so that you can fasten the steel
brackets into a stud. For example, if the studs are 16" or 24" on center, put
the steel brackets even on the end of the bench and fasten with the short
black screws.
3. Attach workbench to wall.
a. Find the studs and make a mark at 36" high. Fasten the long black screws through the steel
bracket into the stud.
b. Next, go in underneath the bench and fasten 2 long white screws
through the bench into each stud.
4. Attach pegboard to wall.
a. Place the pegboard horizontal on the wall, against the bench. Use the
short white screws to attach the pegboard to the wall by placing the
screws down one hole or up one hole from the corner hole in the pegboard.

SHEDorize.com
[phone]
[e-mail]
b. At each stud in the middle of the pegboard, put a short white screw
through the frame of the pegboard into the stud.
c. Place the second pegboard above the first pegboard and repeat the
process to attach it to the wall.
5. Install accessories.
a. For the magnetic jar pack, we recommend installing it up through
the bottom of the bench, either on the side or front of the bench.
b. Finally, arrange the rest of the accessories on the pegboard in a
way that best suits your needs.
Not to exceed 400 pounds.