Siemens RWD68 User manual

Adjusting Temperature Setpoint: RWD 68
X1 Value is the current room temperature
Y1 Value is the cooling signal, 0=no cooling signal, 10=maximum cooling signal
Q1 is the Electric duct heater status

To adjust the cooling setpoint, press the + button until ‘SP-C’ is on the screen
Press ‘SEL’ button, the number value will flash, adjust to desired value using + or – buttons. Press
‘Sel’ button to confirm selection.

To adjust the heating setpoint, press the ‘+’ button until ‘SP-H’ is on the screen
Press ‘SEL’ button, the number value will flash, adjust to desired value using + or – buttons. Press
‘Sel’ button to confirm selection.
Note: The SP-H value must always be lower than the SP-C value, in some cases, both value may need
to be adjusted to select the desired temperature.