Siemens MTE-2 User manual

P/N 315-093304-5
Installation Instructions
Model MTE-2
The Model MTE-2 from Siemens Industry, Inc.
is an enclosure assembly that accommodates
up to six remote telephones.
Fasten the enclosure securely to a clean, dry,
shock-free, and vibration-free surface. Con-
sider the following when mounting the box.
—Mounting height for visual and manual
access to the telephones in the enclosure
—A location that provides easy access to
the remote telephone jacks
—Weight and size of the enclosure
—Local mounting codes
When mounting, position the backbox clear of
obstruction so that the door can open freely
and so that the contents are easily accessible.
TO INSTALL THE MTE-2
1. Slip the door off the hinges of the box and
put it to one side temporarily.
2. Cover the opening in the door by placing
the clear lens over the studs on the door.
3. Fasten the lens to the door using the six
6-32 nuts provided.
4. (Refer to Figure 1.) Place the telephone
cradles plate over the standoffs (marked A)
located near the top of the enclosure.
5. Fasten the plate to the standoffs using the
four 4-40 x 1/4" screws provided.
6. Hold the empty enclosure against the wall
at a height that provides easy access.
Figure 1
Enclosure for the MTE-2
AAAA
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
Siemens Building Technologies, Ltd.
Fire Safety & Security Products
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 CN
(for indoor use only in dry environments)

7. Mark drill points on the wall in the center of
the two slots on the upper rear of the box.
8. Drill the two holes and screw in the top
screws using 1/4" or 3/8" mounting hardware
(user supplied). Leave a small gap between
the wall and each top screw.
9. Mount the enclosure on the two screws and
then install the bottom screws.
10. Tighten all screws securely against the back
wall of the enclosure.
11. Slip the door back on the hinges of the
enclosure.
P/N 315-093304-5