Siemens MAMMOMAT 3000 Setup guide

MAMMOMAT 3000
Register 5 English
Print No.: SPB7-230.091.09.02.02 Doc. Gen. Date: 01.99
Replaces: N/A 65 19 941
© Siemens AG 1999
The reproduction, transmission or
use of this document or its contents
is not permitted without express
written authority. Offenders will be
liable for damages. All rights,
including rights created by patent
grant or registration of a utility
model _or_design,_are_reserved.
SP
Service
Replacing wires in stereotactic device
Repair Instructions
All manuals and user guides at all-guides.com

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 2 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
0 - 2 Revision
Chapter Page Revision
All All 02
All manuals and user guides at all-guides.com

Contents 0 - 3
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 3 of 4 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
1 _______Prerequisites __________________________________________________1 - 1
Purpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 - 1
Tools required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 - 1
Time required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 1
Contents of repair kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 - 1
Important notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 1
2 _______Procedure_____________________________________________________2 - 1
Dismounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 - 1
Reassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3
Page
All manuals and user guides at all-guides.com

0 - 4 Contents
MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 4 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
This page intentionally left blank.
All manuals and user guides at all-guides.com

1 - 1
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 1 of 2 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
Prerequisites 1
Purpose 1
The wires with handels may be replaced due to wear.
Tools required 1
Standard service tools.
Time required 1
Approximately one hour for one person.
Contents of repair kit 1
Amount Name Article no.
1 spare part wire kit 64 83 031
Important notes 1
•Whiledismountingdonotuse excessiveforceortheobjecttabletop might be damaged.
•The pozidrive screws can be very hard toloosen.When unscrewing, be sure of enough
gripwiththepozidrivescrew-driver,so thatthe screws do not getdamaged.
All manuals and user guides at all-guides.com

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 2 of 2 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
1 - 2 Prerequisites
This page intentionally left blank.
All manuals and user guides at all-guides.com

2 - 1
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 1 of 4 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
Dismounting 2
Fig. 1 Dismounting of stereo tactic device
1. Removethe fourscrewsholding the front edge oftheobjecttabletop.
2. Carefully lift the front edge of the object table top to reveal the four screw
placedbehindit.
Removethe revealedscrews,thetwonuts and thetwoguidingpins.
3. Remove thebottom plate by unscrewing the eight remaining screws:
-Two screws at eithersideofthebiopsyunit.
- Four screwsat the bottom of the biopsy unit.
4. Place the biopsy unit asshown in figure1 (pos. 4)
Do not use excessive force or the object table top
might be damaged.
X
Y
Z
mm
mm
mm
X
Y
Z
X
Y
Z
Z
X
Y
MAM00355
MAM00356
4
Object table top
1
2
Guiding
pins Nuts
3
NOTICE
Procedure 2
All manuals and user guides at all-guides.com

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 2 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
2 - 2 Procedure
5. Disconnectthegroundingwirebycarefully unscrewingthescrew.
6. Removethelockingwashersoneon each side.
7. Unhookthesprings.
8. Removethewireswith handels.
MAM00357
5
MAM00361
6
Locking washer
2
Track
Wires with
handels
Wires with
handels
Spring
Spring
7
7
8
8
Fig. 2 Dismounting of wires
All manuals and user guides at all-guides.com

Procedure 2 - 3
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 3 of 4 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
Reassembly 2
1. Removethe lockingwasherfromthe spare part wire kit withpropertool.
2. Reassemblethesparepartwireswithhandels.
3. Securetheringand the springwith the lockingwasher.
4. Reassemblethebiopsyunit.
Make sure that the track in the ring (see pos 2 in fig. 2)
fits to the hook of the spring.
Don´t forget to connect the grounding wire.
NOTICE
NOTICE
All manuals and user guides at all-guides.com

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 4 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
2 - 4 Procedure
This page intentionally left blank.
All manuals and user guides at all-guides.com