
806896A01
s
Walking-Beam Interlock
Módulo de enclavamiento recíproco para interruptores adyacentes
Module d'interverouillage mécanique
1 / 10
Installation Instructions / Instructivo de Instalación
Use only with Siemens certified Components.
Utilizar únicamente con componentes certificados de Siemens.
A utiliser uniquement avec les composants certifiés Siemens.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplyingthis deviceis
turned on.
Couper l'alimentation de l'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puede causar la muerte o lesiones graves. Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage.
Will cause death or serious injury.
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
For Use With Frame NG, PG
Para Usar Con Caja Base NG, PG
U.S. Cat. No. Euro Order No.
Item: WBMPFM 3VL98008LC01
I.L. No. 806896A01
10 mm
Ø = .27“
[ Ø = 7 mm ]
10 mm
Ø = .26“
[ Ø = 6.5 mm ]
Cal ISO 6789
MTRPB 3VL9800-3MJ01 = 24 Vdc
MTRPM 3VL9800-3ML01 = 42-48 V ac/dc
MTRPY 3VL9800-3MS01= 60 V ac/dc
MTRPN 3VL9800-3MN01 = 110-127 V ac/dc
MTRPR 3VL9800-3MQ01 = 220-250 V ac/dc
806892_ _ _
Notice:Control circuit
interlocking recommended to
prevent unintended operation of
the motor operator in conflict with
the walking beam interlock.
[ Aviso: El enclavamiento del
circuito de control es recomendado
para prevenir la operación
involuntaria del accionamiento de
motor en conflicto con el modulo
de enclavamiento mecánico. ]
WBMPFM / 3VL98008LC01
4 X M6 X 16mm
8 X M6 X 1
10 X
6 X M6 X 20mm
-2X
7/16”
NOTE - These instructions do not purport to cover all details or variations in
equipment, or to provide for every possible contingency to be met in
connection with installation, operation or maintenance. Should further information
be desired or should particular problems arise, which are not covered sufficiently
for the purchaser’s purposes, the matter should be referred to the local Siemens
sales office. The contents of this instruction manual shall not become part of or
modify any prior or existing agreement, commitment or relationship. The sales
contract contains the entire obligation of Siemens. The warranty contained in
the contract between the parties is the sole warranty of Siemens. Any statements
contained herein do not create new warranties or modify the existing warranty.
Trademarks - Unless otherwise noted, all names identified by ® are registered
trademarks of Siemens AG or Siemens Industry, Inc. The remaining trademarks
in this publication may be trademarks whose use by third parties for their own
purposes could violate the rights of the owner.