Siemens MAMMOMAT 3000 Setup guide

MAMMOMAT 3000
Register 5 English
Print No.: SPB7-230.091.09.02.02 Doc. Gen. Date: 01.99
Replaces: N/A 65 19 941
© Siemens AG 1999
The reproduction, transmission or
use of this document or its contents
is not permitted without express
written authority. Offenders will be
liable for damages. All rights,
including rights created by patent
grant or registration of a utility
model _or_design,_are_reserved.
SP
Service
Replacing wires in stereotactic device
Repair Instructions

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 2 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
0 - 2 Revision
Chapter Page Revision
All All 02

Contents 0 - 3
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 3 of 4 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
1 _______Prerequisites __________________________________________________1 - 1
Purpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 - 1
Tools required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 - 1
Time required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 1
Contents of repair kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 1
Important notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 - 1
2 _______Procedure_____________________________________________________2 - 1
Dismounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 - 1
Reassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3
Page

0 - 4 Contents
MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 4 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
This page intentionally left blank.

1 - 1
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 1 of 2 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
Prerequisites 1
Purpose 1
The wires with handels may be replaced due to wear.
Tools required 1
Standard service tools.
Time required 1
Approximately one hour for one person.
Contents of repair kit 1
Amount Name Article no.
1 spare part wire kit 64 83 031
Important notes 1
•Whiledismountingdonotuse excessiveforceortheobjecttabletop might be damaged.
•The pozidrive screws can be very hard to loosen.When unscrewing, be sure of enough
gripwiththepozidrivescrew-driver,so thatthe screwsdonotgetdamaged.

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 2 of 2 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
1 - 2 Prerequisites
This page intentionally left blank.

2 - 1
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 1 of 4 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
Dismounting 2
Fig. 1 Dismounting of stereo tactic device
1. Removethe fourscrewsholding the front edge ofthe objecttabletop.
2. Carefully lift the front edge of the object tabletop to reveal the four screw
placedbehindit.
Removethe revealedscrews,thetwonuts and thetwo guidingpins.
3. Remove thebottom plateby unscrewing theeight remainingscrews:
-Two screws at eithersideofthebiopsy unit.
- Four screwsat the bottom of the biopsy unit.
4. Place the biopsy unit as shown in figure 1 (pos. 4)
Do not use excessive force or the object table top
might be damaged.
X
Y
Z
mm
mm
mm
X
Y
Z
X
Y
Z
Z
X
Y
MAM00355
MAM00356
4
Object table top
1
2
Guiding
pins Nuts
3
NOTICE
Procedure 2

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 2 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
2 - 2 Procedure
5. Disconnectthegroundingwire bycarefully unscrewingthe screw.
6. Removethelockingwashersoneon each side.
7. Unhookthesprings.
8. Removethewireswith handels.
MAM00357
5
MAM00361
6
Locking washer
2
Track
Wires with
handels
Wires with
handels
Spring
Spring
7
7
8
8
Fig. 2 Dismounting of wires

Procedure 2 - 3
Siemens-Elema AB Register 5 SPB7-230.091.09 Page 3 of 4 MAMMOMAT 3000
Solna, Sweden Rev. 02 01.99 SPS-UD Service
Reassembly 2
1. Removethe lockingwasherfromthe spare part wire kit withpropertool.
2. Reassemblethesparepartwireswithhandels.
3. Securetheringand the springwiththelockingwasher.
4. Reassemblethebiopsyunit.
Make sure that the track in the ring (see pos 2 in fig. 2)
fits to the hook of the spring.
Don´t forget to connect the grounding wire.
NOTICE
NOTICE

MAMMOMAT 3000 Register 5 SPB7-230.091.09 Page 4 of 4 Siemens-Elema AB
Service Rev. 02 01.99 SPS-UD Solna, Sweden
2 - 4 Procedure
This page intentionally left blank.