Siemens HEATWELL RDE Series Operator's manual

Siemens Building Technologies
RDE… Simple Instructions.
Front Panel: Programming Buttons
Programmed Heating
Constant Heating (Manual)
Economy Heating Temperature or OFF
Controls under the cover on the right hand side.
TO SET CLOCK
Press the Clock Button
Adjust to the current time, using the plus and minus buttons
(please note: the clock is in 24 hour time)
Once the time has set push the enter button or wait for 5 seconds.
(The controller will then return to the main screen)
TO SET THE DAY
1
The day is the Black box’s on the top of the screen with numbers in, Mon= day 1, Tue= day 2 etc
Press the 1… 7 Button, the day it is currently on will flash
Adjust the day by using the plus and minus buttons
Once the correct day is chosen push the enter button or wait for 5 seconds.
TO SET THE HEATING TEMPERATURE
The Heating temperature is the temperature you would like to warm the room up to.
Press the sun button.
Adjust to the required temperature using the plus and minus buttons
Once the desired temperature is chosen push the enter button or wait for 5 seconds.
TO SET THE ECONOMY TEMPERATURE
The Economy Temperature is the lowest temperature you ever want the floor to get to at anytime.
Press the moon button.
Adjust to the required temperature using the plus and minus buttons
Once the desired temperature is chosen push the enter button or wait for 5 seconds.
(This can be made an OFF position by taking the temperature down to OFF. You need to hold the Minus
button for 5 seconds after you get down to the temperature 5 degrees)
For further information contact your underfloor heating installer.
__________________________________________________________
Or contact Siemens NZ Ltd, 09 580 5500 – HVAC Technical Support.
0508 HEATWELL
0508 432 893

Siemens Building Technologies
RDE… Simple Instructions continued.
PROGRAMMING
TO SET THE DAILY TIMES
Move the front vertical slider to the AUTO position.
Press the Blocks button under the panel.
The time setting starts from day 1 at 00.00 in the morning.
The screen will look like this,
Press the moon button for economy heating periods, after you have pushed the moon button you will
automatically advance to the next time period.
Press the sun button for the ON periods, after you have pushed the sun button you will automatically advance
to the next time period.
EXAMPLE - Below is an example of a screen and the heating periods.
If you make a mistake press the blocks button and start again.
When the desired Settings are made push the Enter button , this will save the changes and move you
to day 2 to enter the settings.
Repeat the above steps for days 2-7.
When you are finished, push the Blocks button to return to the main screen.
To check your programs push the blocks button and using the 1…7 button move through the days.
Batteries. (Battery symbol)
If you see the battery symbol on your screen (in the bottom left hand corner) it means your batteries are
getting flat. Remove the batteries and replace with Triple A (AAA) Alkaline batteries. (The batteries are found
in the bottom left hand corner, they slide down in a case) Please note: not all units have batteries.
For further information contact your underfloor heating installer.
__________________________________________________________
Or contact Siemens NZ Ltd, 09 580 5500 – HVAC Technical Support.
0508 HEATWELL
0508 432 893