SignaMax 065-7006 User manual

Signamax  065-1200 series 12-Port Media Converter
User’sManual 1
SignamaxConnectivity Systems
065-7006 5-Port 10/100BaseT/TX Switch
065-7011 8-Port 10/100BaseT/TX Switch
U SER ’ S G UIDE

SignamaxConnectivity Systems
065-7006 5-Port
10/100BaseT/TX Switch
065-7011 8-Port
10/100BaseT/TX Switch
User’s Guide

Signamax  065-7006 5-Port 10/100BaseT/TX and
065-7011 8-Port 10/100BaseT/TX Switches
１
Table of Contents
Table of Contents................................................. １
Packing List ........................................................... ２
FCC Statement...................................................... ２
Introduction............................................................ ３
Product Features.......................................................３
Front Panel ................................................................３
LEDs..........................................................................４
Installation.............................................................. ４
Selecting a Site for the Switch...................................４
Connecting to Your Network......................................５
Specifications........................................................ ５
Contact Information............................................. ６

Signamax  065-7006 5-Port 10/100BaseT/TX and
065-7011 8-Port 10/100BaseT/TX Switches
２User’s Manual
Packing List
Please inspect the contents and report any apparent damage or missing items
immediately to our authorized reseller.
•The Signamax065-7006 or 065-7011 Switch
•This User’s Manual
•AC to DC power Adapter
FCC Statement
The FCC (Federal Communications Commission) restricts the amount of radio
frequency emission and radiation coming from computer equipment. The Ethernet
switch stated in this manual has been tested and found to comply with the limits for
a Class A digital device pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user is required to correct the interference at
his/her own expense. Any changes or modifications not expressly approved by the
manufacture would void the user’s authority to operate the equipment.

Signamax  065-7006 5-Port 10/100BaseT/TX and
065-7011 8-Port 10/100BaseT/TX Switches
User’sManual ３
Introduction
The Signamax065-7006 and 065-7011 switches are a 5/8-port Fast Ethernet
switch, integrating 10/100BaseT/TX networks in a cost-effective pocket size
package. The TX ports can auto-sense speed and half/full duplex modes, and they
also provide an auto-MDIX function for easy switch uplinking.
Product Features
•5 or 8 ports supporting 10/100BaseT/TX.
•Each port auto-negotiates for 10/100Mbps speed, auto-detects full or half
duplex mode, and has an auto-MDIX capability to eliminate the need for
crossover cables.
•Broadcast storm filter function.
•True non-blocking architecture.
•Full wire-speed forwarding rate.
•Store-and-forward mechanism.
•Back-pressure and IEEE 802.3x compliant flow control.
•Supports 2 K MAC addresses.
•Supports 1 Mb buffer memory.
•Front panel power and port status LEDs.
•Wall-mountable pocket size.
Front Panel
The front panel of the switch has an array of LED indicators to provide you with
instant feedback on the status of the switch.
Figure 1: Front & rear panels

Signamax  065-7006 5-Port 10/100BaseT/TX and
065-7011 8-Port 10/100BaseT/TX Switches
４User’s Manual
LEDs
The array of LED indicators on the front panel conveys status and configuration
information to help you monitor and troubleshoot the switch.
ŒPower This LED comes on when the switch is connectedtothepoweradapter.
• Port Status Each port has a LED, indicating the port status.
ŽPower Adapter Connect the supplied AC to DC adapter to the receptacle on
the back of the switch, then plug the cord into a standard AC outlet with a voltage
range from 100 to 240 VAC.
Table 1: Port Status
LED State Indication
Steady The port has established a valid network connection.
LNK stands for LINK.LNK/
ACT Flashing The port is transmitting or receiving data.
ACT stands for ACTIVITY.
Installation
Selecting a Site for the Switch
As with any electronic device, you should place the switch where it will not be
subject to extreme temperatures, humidity, or electromagnetic interference.
Specifically, the site you select should meet the following requirements:
•The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to
40 degrees Celsius).
•The relative humidity should be less than 90 percent, non-condensing.
•Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for IEC 801-3, Level 2 (3V/M) field strength.
•Make sure that the switch receives adequate ventilation. Do not block the
ventilation holes on the side of the switch or the fan exhaust port on the rear of the
switch.
•The power outlet should be within 6 feet (1.8 meter) of the switch.

Signamax  065-7006 5-Port 10/100BaseT/TX and
065-7011 8-Port 10/100BaseT/TX Switches
User’sManual ５
Connecting to Your Network
Connect network cables from computers or network segments to the TX ports on the
back of the unit.
Table 2: Cabling Information
Speed Connector Port Speed
Half/Full Duplex Cable
100BaseTX RJ-45 100/200 Mbps 100 m, Category 5 STP/UTP
10BaseT RJ-45 10/20 Mbps 100 m, Category 3, 4, or 5
STP/UTP
Specifications
Applicable Standards IEEE 802.3, 10BaseT
IEEE 802.3u, 100BaseTX
LED Indicators Per unit–Power Status
Per Port–LNK/ACT
Cable 10BaseT 2-pair UTP/STP Cat. 3,4,5, up to 100m
100BaseTX 2-pair UTP/STP Cat.5, up to 100m
Switching Methods Store-and-Forward
Forwarding Rate 14,880 packets per second (pps) for 10 Mbps,
148,800 packets per second (pps) for 100 Mbps
AC Input 100~240 Volts AC, 50-60 Hz, external Universal power supply
Power consumption 12 Volts DC, 0.6 Amps, 7.2 Watts
Operating Temperature 32°F ~ 104°F (0°C ~ 40°C)
Storage Temperature -13 F°~ 158°F (-25°C ~ 70°C)
Humidity 10 % ~ 90 %, non-condensing
Emissions FCC part 15 Class A, CE Mark
Dimensions 6.3 in. x 3.2 in. x 1.1 in. WxDxH (160 mm x 81 mm x 28 mm)
pocket size
Weight 0.92lb. (0.42kg)

Signamax  065-7006 5-Port 10/100BaseT/TX and
065-7011 8-Port 10/100BaseT/TX Switches
６User’s Manual
Contact Information
SIGNAMAX  CONNECTIVITY SYSTEMS
An AESP Company
1810 N.E. 144th Street.
North Miami, Florida 33181, U.S.A.
Phone: [phone] Fax: [phone]
Sales: 800-446-2377 Tech. Support: 800-446-2377, ext. 201
Http://www.signamax.com
E-mail: [email protected]
EUROPE
AESP Ukraine. (UKRAINE)
2 Timiryazevskaya St. 47
252014 Kiev, Ukraine
Phone: [phone]
Fax: [phone]
Http://www.aesp.com.ua
E-mail: [email protected]
AESP Sweden. (SWEDEN)
Grevegatan 19-21 SE-815
40 TIERP. SWEDEN
Phone: [phone]
Fax: [phone]
Phone: [phone]
Http://www.aesp.se
E-mail: [email protected]
JOTEC AESP AS. (NORWAY)
Telefon [phone] Ordrefax 23
14 17 10 Karihaugveien 102
Postboks 50 Ellingsrudasen 1006
Oslo, Norway
Phone: [phone]
Fax: [phone]
Http://www.jotec.no
E-mail: [email protected]
AESP Russia. (RUSSIA)
Kronshtadtsky Blv.
125499 Moscow, Russia
Phone: [phone]
Phone: [phone]
Fax: [phone]
Http://www.aesp.ru
E-mail: [email protected]
AESP Germany GmbH
(GERMANY)
Weisserfelderstr.2 D-85551
Kircheim b. München, Germany
Phone: [phone]
Fax: [phone]
E-mail: [e-mail]
INTELEK spol.s.r.o
(CZECH REPUBLIC)
Vlarska 22,
Brno, CZ 62700
CZE Czech Republic
Phone: [phone]
Fax: [phone]
Http://www.intelek.cz
E-mail: [email protected]