SignaMax C-600 Series User manual

C-600 Series Genisys Solution
Guide

Genisys Solution Guide
- 2 -
SC60010
C-600 24 Port Gigabit PoE++ Managed Switch 2 SFP Combo Port

- 3 -
How to Use This Guide
This guide includes detailed instructions on how to optimize a C-600
Series switch for use with Genisys PoE Lighting System based on the
requirements and information provided by Innovative Lighting.
Who Should Read
this Guide?
This guide is for network administrators who are responsible for
operating and maintaining network equipment. The guide assumes a
basic working knowledge of LANs (Local Area Networks), the Internet
Protocol (IP), the Internet Group Management Protocol (IGMP) and
quality of Service (QOS).
Related
Documentation
This guide focuses on switch software configuration through the web
browser.
For hardware installation please refer:
Quick Start Guide
For detailed configuration options and information about the switch’s key
features please refer:
Web Management Guide OR CLI Reference Guide
Revision History
This section summarizes the changes in each revision of this guide.
Revision
Date
Description
v1.0.0
2020/11/17
Initial Release

Contents
- 4 -
Contents
How to Use This Guide .............................................................................................................. 3
C-600 Series Genisys Configuration via Web Interface........................................................... 5
Device Management System (DMS)............................................................................................. 6
Power over Ethernet (PoE) Mode................................................................................................. 7
Power Mode................................................................................................................................. 8

Dante Solution Guide
- 5 -
C-600 Series Genisys
Configuration via Web Interface
See the Preparation for Web Interface section of the Web Management Guide for how to
connect and login to the C-600 Switch

- 6 -
Device Management System (DMS)
1. Disable Device Management System (DMS)
oGenisys recommends disabling the built in Device Management System of the C-600
Series switch.
oBy default DMS is disabled on the C-600 Series switches but if it was previously
enabled it can be disabled by going to the DMS menu
oChoosing DMS Mode
oMode: Select Disabled in the drop down menu
oClick Apply

- 7 -
Power over Ethernet (PoE) Mode
1. Configure PoE Mode:
oNavigate to Switch-> Configuration - > PoE - > Configuration
oFor each port that will have Genisys units select PoE Mode:4-Pair
oFor each port that will have Genisys units select Maximum Power: 60

- 8 -
Power Mode
1. Configure secondary power supply to “Boost”mode:
oBy default the secondary power supply on the C-600 Series switch is set to Boost mode but if it
was previously changed to Redundant mode it can be set as follows:
oNavigate to Switch->Configuration->System->Power Information
oOperating Mode: Boost
oClick Apply

- 9 -
Startup Config
1. Saving the configuration file
oClick the Save Current Settings button in the upper right of the screen