Signature Hardware NEO-ANGLE SHOWER CURTAIN ROD User manual

1Neo-Angle Curtain Rod Installation Instructions
INSTRUCTIONS
Unpack and inspect the product for any
shipping damages. If you find damages, do not
install. Contact Customer Service at
1.866.855.2284. If you need assistance or have
questions while installing your shower rod
contact Customer Service.
We recommend consulting a professional if
you are unfamiliar with installing bathroom
fixtures. Signature Hardware accepts no liability
for any damage to the walls or ceiling, or for
personal injury during installation.
TOOLS AND MATERIALS:
Read entire shower rod installation Instructions.
Observe all local building and safety codes. For
the following installation instructions it is
assumed that any old fixtures have been
removed and any repairs to the wall have
been completed.
BEFORE INSTALLING INSTALLATION
1. Lay the rod sections on the floor. Assemble the rod with the
connector piece.
2. Verify that the rod sections are the proper length for your
installation. If not, trim with a hacksaw.
3. Hold the wall brackets up at the desired mounting height.
NEO-ANGLE SHOWER CURTAIN ROD
Pencil
Tape Measure
Level
Screwdriver
Drill
Hammer
Hacksaw ¼" Drill Bit
Measure and trim.

Neo-Angle Curtain Rod Installation Instructions 2
INSTALLATION
5. Drill pilot holes for the wall anchors.
Note: If there is a stud in your mounting location, use wood screws to
attach the wall brackets.
6. Gently tap the anchors into the pilot holes with a hammer.
7. Attach the rod and brackets to the wall with the
mounting hardware provided.
4. Mark the placement of the mounting holes. Use a tape
measure and level to make sure that your pencil marks are
lined up properly on each wall.
8. Slide the 1" loop onto the curved section of the rod.
9. Insert the ends of the rod into the wall brackets.
Tighten the set screws with a Philips head screwdriver
to secure.
NEO-ANGLE SHOWER CURTAIN ROD
X X
Ensure that the markings
are lined up properly.
Mark mounting holes.
X
Pilot Hole
Anchor
Tap anchors into
pilot holes.
Pilot Hole

3
Neo-Angle Curtain Rod Installation Instructions
INSTALLATION
NEO-ANGLE SHOWER CURTAIN ROD
10. Mark the location of the celling support and measure
the distance between the ceiling and the rod. If
necessary, trim the ceiling support to the proper length
with your hacksaw.
11. Once the support is ready, insert it into the 1" loop.
Attach the ceiling bracket to the other end and tighten
the set screws.
12. Hold the ceiling support in place and mark the
location of the mounting holes.
13. Drill pilot holes for the anchors and tap the anchors in with
a hammer.
14. Attach the ceiling bracket.
Mark ceiling
support location.
Anchor
Tap anchors into
pilot holes.
Pilot Hole