Signature Hardware K-US13 User manual

K-US13 shower enclosure
installation instruction

1
Note: Please read these instructions carefully before installing.
Please check the quantity of the accessories and check for broken products.
1Tools for installation
Impact drill Level Rubber hammer Glue
Pencil Screw driver Tape
3mm/4mm
Allen key Knife
2Tray installation
Put the water pipe of the shower
tray into the drain outlet.
Tray
Concrete
layer
Wall
ST4*25 Up stand
Wall
Magnification ref.drawing
1 for B area
Magnification ref.drawing
2 for B area
B

2
3Installation for wall profile
2
3
4
1
ST4*25

3
1
2
4

4
5
ST4*25

5
6

6
7
Wate bar
ST4X16

7
8
Spring roller
Spring roller

8
9
2 4

Shower Enclosure Maintenance
1. Cleaning
 Use a soft, dry cloth to clean. If necessary, clean with alcohol using a soft
cloth or sponge to remove dirt.
 Do not use the following products to clean the shower enclosure: acidic
solvents, alkaline solvents, hydrochloric acid, acetone thinners, scouring
powder. These products may harm the shower enclosure.
2. Use and maintenance of sliding door rollers
 Avoid shaking the door. This may cause the rollers to come off track and
the door to fall.
 Add lubrication to the roller track on a regular basis after regular cleaning.
 Adjust screws on a regular basis to ensure effective operation.
3. Maintenance of Tempered Glass
 Do not use sharp objects, such as knives, to scrape the glass.
 Do not use corrosive cleaners.
 Do not wipe the surface with any rough material.
4. Maintenance of Aluminum Frame
 Do not use sharp objects, such as knives, to scrape the glass.
 Do not use corrosive cleaners.
 Do not wipe the surface with any rough material.
5. Usage and Maintenance of Acrylic Shower Tray
 Do not use sharp objects, such as knives, to scrape the surface.
 Do not use corrosive cleaners.
 Do not wipe the surface with any rough material.
 Remove labels before use.