Signature Hardware KNOX WATERFALL TUB SPOUT WITH HAND SHOWER User manual

1Knox Waterfall Tub Spout with Hand Shower Installation Instructions
Teflon Tape
Phillips Screwdriver
Ruler
Pencil
KNOX WATERFALL TUB SPOUT WITH HAND SHOWER
INSTALLATION INSTRUCTIONS
Before installing, read entire Installation Instructions. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1.866.855.2284. If you need assistance or have questions while installing your tub spout, contact
Customer Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom and plumbing xtures. Signature
Hardware accepts no liability for any damage to the spout, installation surface, or for personal injury during installation.
3mm Wrench
Level
TOOLS AND MATERIALS:
INSTALLATION DIMENSIONS:
7-3/4"
12mm Wrench
9-1/4"
5-3/4"±1/2"
1/2" Female IPS
1/2" Female IPS

2Knox Waterfall Tub Spout with Hand Shower Installation Instructions
INSTALLATION:
1. Install hot and cold 1/2" female IPS water supplies
in the wall with a 5-3/4" distance between them.
2. Unscrew the M4 screws and loosen the M6 screws
from the faucet body. Remove the leveling plate
and offset connectors.
3. Measure the thread depth of the pipe joints with
your ruler. Your ttings should be ush with the
nished wall.
4. Wrap the offset connectors with teon tape.
5. Place the offset connectors through the leveling
plate and screw them into the pipe joints. Tighten
slightly wtih the 12mm hex wrench.
6a. Adjust the offset connectors with the 12mm hex
wrench until the plate is level.
Cold Water
Pipe Joint
Hot Water
12mm Wrench
5-3/4"±1/2"
Faucet Body M6 Screw
Offset
connector Plate M4 Screw
Leveling

3Knox Waterfall Tub Spout with Hand Shower Installation Instructions
6b. Use your level to ensure the plate is properly
aligned.
7. Tighten the inlet thread joint with the 12mm hex
wrench.
8. Install the faucet body on the offset connectors.
Level
9. Tighten the M6 screws with the 3mm hex wrench.
10. Run water to ensure the spout was installed
properly, no water should be leaking. Turn the
diverter knob counter-clockwise to divert the water
to the tub spout spout.
11. Turn the diverter knob clockwise to divert the
water to the hand shower.
Diverter Knob

4Knox Waterfall Tub Spout with Hand Shower Installation Instructions
1. Use a pointed tool to remove the screw cap.
Remove the screw, thermostatic handwheel, top
collar, and locking nut to remove the thermostatic
cartridge.
2. Clean the lter with a brush and vinegar.
3. Re-install the thermostatic cartridge, and secure
the locking nut and the stop collar.
CLEANING:
If ow rate is low or temperature control seems imprecise, the thermostatic cartridge lter may be blocked. Shut off the
main water supply before cleaning the lter.
Thermostatic
Cartridge Locking
Nut
Stop
Collar
Thermostatic
Handwheel
Screw Cap
Filter Net
Cover
Plate Slot
4. Fit the thermostatic handwheel onto the cartridge,
tighten the screw and replace the decorative cap.