Skope OD1100N User manual

Page 1 of 4
Large Open Deck Fridge
PRN80334 Rev. 1.0 Apr. 2022
User Guide (OD1100N/OD720N)
Safety
Always observe safety precautions when using any electrical appliance. Read these instructions carefully and keep them for future reference.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
• Do not use this appliance for other than its intended use.
• Do not insert fingers/foreign objects into any holes.
• Only use this appliance with the voltage specified on the cabinet rating label.
• Ensure the appliance has adequate ventilation as this is essential to economical, high performance.
• Be careful not to touch moving parts and hot surfaces.
• For your own safety and that of others, ensure that all electrical work is done by authorised personnel.
• If the power supply flexible cord becomes damaged, it must be replaced by an authorised service agent or similarly qualified person in order
to avoid a hazard.
• Ensure all necessary safety precautions are observed during installation or removal of the refrigeration unit.
• The appliance is not designed to be stable while in motion. Use extreme caution when moving or transporting it.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• If the cabinet is to be scrapped, ensure the cabinet is unplugged from the power supply and cut off the mains flex close to the back of the
cabinet. Be mindful of the risk of animals or children becoming trapped in the appliance – either remove or secure doors if necessary.
• Refrigerant must be removed by a qualified service person and the cabinet recycled/disposed of in accordance with local regulations.
The fridge is designed to operate within a specific climatic class environment. The cabinet rating label inside the fridge lists the climate class number.
The cabinet rating label includes relevant hazard symbols that may be associated with the fridge. Refer to the information below.
Installation
The fridge has been installed by SKOPE in a suitable location and should not be moved. If you need to reposition the fridge, consult your sales
representative. The fridge should not be installed near air-conditioning outlets, heaters, doorways or drafts.
Ventilation
To prevent overheating and conserve energy, ensure there is always at least a 50 mm gap at the back, 200 mm on the top and 60 mm at the sides of the
cabinet. Keep the ventilation slots in the lower front panel clear at all times. Never store cardboard cartons or other objects in front of the fridge.
Ensure both rear spacers are fully extended outwards and locked into place. This will provide the necessary air gap at the rear of the cabinet for correct
operation.
WARNING
• Ensure the appliance is disconnected from the power supply before performing any cleaning or maintenance.
• Do not cover the grilles or block the entry or exhaust of airflow by placing objects up against the refrigeration unit.
• Should manual defrosting be necessary, turn off the refrigeration system and allow the ice to melt by air circulation. Collect
ice and water during defrost to prevent a slip hazard. Do not use mechanical methods to remove ice, as this may damage
the refrigeration circuit.
• Do not use any electrical devices or appliances inside the food storage compartment.
Climate class Ambient temperature Relative humidity
3 25°C 60%
WARNING
The refrigeration system contains flammable R290 refrigerant. Do not tamper with it.
The refrigeration system must only be serviced by qualified personnel.
Back of fridge
Rear spacer – 50 mm
when fully extended

Page 2 of 4
Large Open Deck Fridge
PRN80334 Rev. 1.0 Apr. 2022
Using the Fridge
The fridge is run by an electronic controller which monitors use and automatically switches the fridge between “Day” mode, and energy-saving
“Night” mode when the night blind is opened and closed.
Do not overload the power supply.
Lighting
The cabinet is lit by 7.5 W LED modules which are not user-replaceable and must not be tampered with in any way. The OD1100N sign is lit by a 7.5 W
sign light. If any lighting is not working properly arrange a service call.
Night Blind
The fridge is fitted with a manual night blind which has a switch that automatically tells the electronic controller to run the fridge in Day mode (with the
lights on) when in the open position, or Night mode (with the lights off) when the blind is in the closed position, saving power.
The night blind is located at the top of the cabinet opening and is not visible when in the open position.
During store closing hours use the handle to pull the blind down and hook it under the night blind retaining brackets at the bottom of the fridge opening.
To open, use the handle to release the blind from the retaining brackets, and control the blind as it opens.
Shelves
Cleaning and Maintenance
To ensure the fridge continues to run efficiently and reliably, carry out the following cleaning tasks routinely. Always disconnect the fridge from the power
supply before cleaning or maintenance.
OD720N OD1100N
3 adjustable angle (8° or flat), adjustable height shelves + 1 fixed angle
(8°) bottom shelf.
Top two shelves: 1170W × 374D, 3rd shelf: 1170W × 394D, bottom shelf:
1177W × 424D
4 adjustable angle (8° or flat), adjustable height shelves + 1 adjustable
angle (8° or flat) bottom shelf. Optional gravity feed system available.
Top two shelves: 1170W × 360D, middle two shelves: 1170W × 380D,
bottom shelf: 1179W × 400D
All shelves except the bottom shelf are held in place by two cantilevered shelf brackets which clip into cut-outs in the cabinet back duct. The height of
these shelves can be vertically adjusted at 28 mm increments.
There is a maximum load of 46 kg per shelf. Do not overload the shelves. Remove product if the shelf is flexing.
Frequency Task
Regularly Wipe the inside and outside of the fridge with a damp cloth.
Clean up any spills as they occur.
Lower the night blind and wipe the front and back with a damp cloth. Do not use hot water, as this may damage the material.
Monthly Remove and clean the air filter (see instructions below).
Six-monthly Arrange a service technician to clean the air filter and condenser coil.
Yearly Remove the gravity feed matting (if fitted) and thoroughly clean the shelves and matting.
Clean the debris catch tray under the bottom shelf – OD1100N only (see instructions below).
Inspect the power cord for damage. If damage is found, disconnect the fridge from the power supply immediately and arrange service.
Position for
level shelves
Position for
angled shelves
Excess shelf light
cable holes

Page 3 of 4
Large Open Deck Fridge
PRN80334 Rev. 1.0 Apr. 2022
To remove and clean the air filter
1. Disconnect the fridge from the power supply.
2. To remove the filter, use the finger loops to pull the filter up
and detach from the front panel.
3. Clean the filter with a vacuum cleaner, wash with cold water
and shake excess water off before refitting. Do not apply hot
water, blow dry or place in a dishwasher. If necessary, discard
and refit a new air filter.
4. To refit the filter, insert it up into the locating bracket on the top
face of the front panel vent with the finger loops facing out.
Then clip the filter into the slots on the bottom face of the front
panel vent.
To clean the debris catch tray under the bottom shelf (OD1100N only)
There is a debris tray to catch any small objects that fall into the interior of the cabinet and prevent them falling into the refrigeration system. The
tray sits under the bottom shelf and is fixed in place.
Note that the debris catch tray is not designed to be watertight so any liquid spills should be cleaned up immediately.
1. Disconnect the fridge from the power supply.
2. Remove product from the bottom shelf.
3. Lift the bottom shelf and reach under to remove objects and
wipe the tray clean.
Air filter Finger loops
Debris catch tray
Bottom shelf (raised)

Page 4 of 4
Large Open Deck Fridge
PRN80334 Rev. 1.0 Apr. 2022
Troubleshooting
Before calling for service, check the troubleshooting tips below:
Problem Solution
Fridge not operating Check that the power cord is plugged in correctly.
Check the mains power supply.
Warm temperatures Move the product away from the airflow slots.
Clean the air filter (see above).
Ensure that there is an adequate ventilation gap around the top, bottom and sides of the cabinet.
Check that the fridge is not affected by heat sources such as heaters or the sun, and/or air currents including
air-conditioning outlets, heaters and doorways. Contact your SKOPE representative for advice.
Lights not on Open the night blind to switch to Day mode and turn the lights on.
Lights not working Arrange a service technician to replace the faulty component.