Skope OD360N User manual

Page 1 of 4
SKOPE Open Deck Fridge
OD360N, OD400N, and OD460N
PRN80380 Rev. 1.0 Feb. 2023
User Guide
Thank you for purchasing a SKOPE refrigeration product.
Safety
Always observe safety precautions when using any electrical appliance. Read these instructions carefully and keep them
for future reference.
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
•Do not use this appliance for other than its intended use.
•Do not insert fingers/foreign objects into any holes.
•Only use this appliance with the voltage specified on the cabinet rating label.
•Ensure the appliance has adequate ventilation as this is essential to economical, high performance.
•Be careful not to touch moving parts and hot surfaces.
•For your own safety and that of others, ensure that all electrical work is done by authorised personnel.
•If the power supply flexible cord becomes damaged, it must be replaced by an authorised service agent or similarly qualified
person in order to avoid a hazard.
•If installing or removing the refrigeration unit, refer to the Installation Guidelines below, and observe all necessary safety
precautions.
•The appliance is not designed to be stable while in motion. Use extreme caution when moving or transporting it.
•Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
•If the cabinet is to be scrapped, ensure the cabinet is unplugged from the power supply and cut off the mains flex close to the
back of the cabinet. Be mindful of the risk of animals or children becoming trapped in the appliance – either remove or secure
doors if necessary.
•Refrigerant must be removed by a qualified service person and the cabinet recycled/disposed of in accordance with local
regulations.
Troubleshooting
Before calling for service, check the troubleshooting tips below:
WARNING
•Ensure the appliance is disconnected from the power supply before performing any cleaning or maintenance.
•Do not cover the grilles or block the entry or exhaust of airflow by placing objects up against the refrigeration unit.
•Should manual defrosting be necessary, turn off the refrigeration system and allow the ice to melt by air circulation. Collect
ice and water during defrost to prevent a slip hazard. Do not use mechanical methods to remove ice, as this may damage
the refrigeration circuit.
•Do not use any electrical devices or appliances inside the food storage compartment.
This cabinet is designed to operate within a specific climatic class
environment.
There are hazard symbols on the cabinet. See the information below
for symbol definition.
The cabinet rating label inside the fridge lists the climate class number. WARNING
The refrigeration system contains flammable R290 refrigerant.
Do not tamper with it.
The refrigeration system must only be serviced by qualified
personnel.
Climate class Ambient temperature Relative humidity
325°C 60%
Problem Solution
Fridge is not operating Check that the power cord is plugged in correctly.
Check the mains power supply.
Warm temperatures
Move product away from the airflow slots.
Clean the air filter (see “To clean the air filter and coil” on page 4).
Ensure there is an adequate ventilation gap around the top, bottom, rear, and sides of the cabinet.
Check that the fridge is not affected by heat sources, e.g. heaters or the sun, and/or air currents, including
air-conditioning outlets, heaters and doorways.

Page 2 of 4 PRN80380 Rev. 1.0 Feb. 2023
SKOPE Open Deck Fridge
OD360N, OD400N, and OD460N
Installation Guidelines
Ensure the installation guidelines below are considered and met.
Ventilation and Clearance Requirements
Make sure there is adequate ventilation around the refrigeration cartridge and cabinet at all times. Refrigeration exhaust air must
not be restricted, and must be able to flow easily out and away from the cabinet.
Cleaning Before First Use
You must thoroughly clean and sanitise the inside the cabinet before using it for the first time. Make sure you unplug the cabinet
from the power supply before cleaning. If required, clean the cabinet exterior according to “Routine Cleaning” on page 4.
Power Cord
Before final positioning of the cabinet, pull the power cord out and connect it to the power supply.
Ventilation
Ensure all ventilation
requirements below
are met.
Sunlight
Do not install the
cabinet in direct
sunlight.
Uneven Surface
Do not install the
cabinet on an uneven
surface.
Surface
The installation
surface must be
capable of supporting
the loaded cabinet.
Power Supply
Do not overload the
power supply.
Blocking Ventilation
Do not store boxes or
items in front or on
top of the cabinet.
Climate Class
The cabinet must be installed
in an environment within its
climate class.
The climate class is stated on
the cabinet rating label, and
explained on the front page of
this user guide.
Drafts
Do not install near
air-conditioning
outlets, heaters,
doorways or drafts.
30 mm (min)
(rear spacer)
50 mm recommended
60 mm (min)
200 mm
(min)
60 mm (min)
Exhaust
air
Exhaust
air
Air
intake
Air
intake
Back wall
Back wall
Exhaust
air 100 mm
(min)
Freestanding installation ventilation requirements Enclosed installation ventilation requirements
Exhaust air
must NOT
run across
the top of
the cabinet.

Page 3 of 4
SKOPE Open Deck Fridge
OD360N, OD400N, and OD460N
PRN80380 Rev. 1.0 Feb. 2023
Shelves
The fridge is supplied with three metal shelves. Optional gravity feed matting and shelf dividers are available for each shelf.
Loading product
Let the cabinet cool down to the desired temperature before loading it with product. When loading the cabinet:
Electronic Controller
The electronic controller regulates the cabinet internal temperature, signals alarms, captures
operational information and controls the lights. The internal temperature is set at the factory for
an open deck fridge (all shelves maintain temperatures below 5°C).
To customise the settings to your requirements and view historical data, download the
SKOPE-connect app from the Google Play Store or Apple App Store, and connect via Bluetooth
wireless technology.
Lights
The fridge is fitted with LED shelf lights. The lights will switch on when the cabinet is plugged in,
and can be dimmed and turned off using the electronic controller.
OD360N OD400N OD460N
Dimensions Max load Dimensions Max load Dimensions Max load
Top Adjustable height and angle shelf
(800W × 340D) 45 kg Adjustable height and angle shelf
(800W × 270D) 36 kg Adjustable height shelf (1100W × 270D) 48 kg
Middle Adjustable height and angle shelf
(800W × 350D) 45 kg Adjustable height and angle shelf
(800W × 295D) 36 kg Adjustable height shelf (1100W × 295D) 48 kg
Bottom Flat or angled shelf
(805W × 365D) 45 kg Fixed angle shelf
(805W × 330D) 45 kg Fixed angle shelf (1100W × 330D) 60 kg
Alternative height adjustable slots
Position for angled shelves
Position for
level shelves
Shelf Flexing
Remove product if the
shelf is flexing.
Shelf Overhang
Do not let product
hang over the shelves.
Load Limit
Do not load product
above the load limit
indicators.
Shelf Spacing
The shelves are set to
ensure product fits and
slides correctly, and
shouldn’t be adjusted.
MAX
load
per shelf
Front Back
Top
Internal Airflow
Leave 25 mm space
between product and
the back of cabinet.
Shelf Loading
Do not overload the
shelves. See the
loading limits above.
LOAD LIMIT
Apple App
store
Google Play
store

Page 4 of 4 PRN80380 Rev. 1.0 Feb. 2023
SKOPE Open Deck Fridge
OD360N, OD400N, and OD460N
Electrics
Disconnect the cabinet from the power supply before attempting any maintenance or cleaning.
Routine Cleaning
Ensure the cabinet is unplugged from the power supply before cleaning.
IMPORTANT: Do not use abrasive, corrosive or solvent-based cleaners, as they could damage the protective coating on the
exterior. Do not wash any liquid down into the refrigeration system, as this could lead to refrigeration failure.
Wipe both the interior and exterior of the cabinet with a damp cloth. Take care to keep moisture away from electrical parts.
Remove the bottom shelf to help with cleaning by undoing the two side fixing screws. Make sure you refit the bottom shelf before
reconnecting the fridge to the power supply.
You must keep the condenser coil and condenser filter clean. SKOPE strongly recommends monthly cleaning of the condenser
coil and air filter. A thorough cleaning is required by qualified service personnel every six months.
Do not use hard or sharp tools to clean the coil as these may cause damage.
Service and Support
We know you will get years of satisfaction from your new SKOPE product when you follow a few simple preventative maintenance
guidelines.
Helpful information is available on the SKOPE website
www.skope.com/serviceandsupport
To isolate the electrics
1. Switch the cabinet off.
2. Unplug the power cord from the power supply.
To clean the air filter and coil
1. Unplug the cabinet from the mains power supply.
2. Undo the 2 × thumb screws and remove the kick panel.
3. Unclip the filter from the condenser coil. Clean with a vacuum cleaner, wash with
cold water, and shake off any excess water before refitting.
•Do not use hot water, blow-dry, or place in a dishwasher.
•If necessary, discard and refit a new filter.
4. Brush the condenser coil with a soft brush to remove any dust and fluff.
5. Replace the filter.
6. Refit the kick panel.
7. Plug the cabinet back in to the mains power, and check for correct operation.
Kick panel
Thumb screws
Filter
Coil