SKY-HERO Spy SKH00-301 User manual

Spy
Assembly instructions
You’ve never been
so close to be a Hero …
Kits SKH00-301, SKH00-302 & SKH00-303
Assembly instructions Spy / Kits SKH00-301, SKH00-302 & SKH00-303 / Page 1/5

1
Mount de 3 frame-spacers.
Screws used: PT 2,9*13mm
-
2
Mount de 2 landing gear holders.
Screws used: M3*10mm + M3 locknut PT 3*10mm
Tip : Glue de screw in place on your frame for later easy
gear holder replacement…
-
3
Mount de 4 silent blocks.
Screws used: M4*10mm round head
4
Mount your motors on motor holders.
Tip : Use the screws provided with your motor and add
some threadlock
Assembly instructions Spy / Kits SKH00-301, SKH00-302 & SKH00-303 / Page 2/5

5
Connect your ESC to your motors.
Tip : Check your cable length depending on your frame
size and ight controller.
Check your motor rotation depending on your ight
controller recommendations.
-
6
Mount 2 motor holders on each arms.
Screws used: M3*10mm + M3 locknuts
Tip : Align the centering pins from your motor holders with
the arms holes.
-
7
Insert the arms insert on each arm.
8
Mount the 3 arms on your frames.
Screws used: M4*40mm cone head +Knuckel
Tip : Use only the inner hole, with knuckle on top, this is
just a blank mounting.
Assembly instructions Spy / Kits SKH00-301, SKH00-302 & SKH00-303 / Page 3/5

9
Place your ight controller and RX, route all your cables.
Tip : The center of your frame is the hole…
Use the 45 * 45 mm pattern for suitable ight
controllers.
-
10
Remove the knuckles and mount the upper frame.
Use M4*40mm buttonhead in rear outer hole for xing
canopy standof.
Screws used: PT 2,9*13mm, M4*40mm cone head +
knuckel, M4*40mm buttonhead
-
11
Remove the 4 rst M4*40 screws, mount them in the right
direction.
Screws used: M4 locknuts + M4 shims
-
12
Mount your inertic plate.
Screws used: M4 red knuckle
Assembly instructions Spy / Kits SKH00-301, SKH00-302 & SKH00-303 / Page 4/5

13
Mount your landing leg, landing poles and landing caps.
Screws used: M3*16mm + M3 locknuts
Tip : Check the for correct logo orientation
-
14
Screw the quick release nut on landing gear holder and
slide legs into it.
Tip : Do not over tight the nut and never tight it with no leg
into it
-
15
Drill a 8mm hole in your canopy and glue the grommet
holder in place.
NB: Spyder canopy showed
Tip : Drill rst a small hole, and use a reamer to get the
right size, use thich CA glue
-
16
Mount the grommet into holder,
x the canopy with the body clip.
NB: Spyder canopy showed
Assembly instructions Spy / Kits SKH00-301, SKH00-302 & SKH00-303 / Page 5/5