Slinex Unique Direct Series User manual

{ Design. Uniqueness. Innovations }
SQ-04 4ʹʹ video door phone
Thank you for the
choice of our equipment
User manual
UNIQUE
DIRECT
SERIES

{ Design. Uniqueness. Innovations }
1Rev. 1.0 2
Attention!
As a result of continuous upgrades and functionality improvements, technical
characteristics of the device can be changed without any preliminary declaration.
This manual can contain some inaccuracy or misprint. The owner reserves the right to
make corrections to the information described in the user manual and device package.
The last revision of this manual is available on www.slinex.com
Safety instructions
Read and keep that manual.
The device installation process should be carried out by the qulied specialists.
Use the device from the –10 ˚C to +55 ˚C (14 ˚F to 131 ˚F), always keep it within that temperature range.
Installation surface should be free from vibration and impact inuence.
Keep this device far from open sources of heat, such as radiators, heaters, and ovens.
The device can be installed near other electronic equipment in case if the temperature of the environment
does not exceed previously mentioned range.
The device should be protected from the direct inuence of the natural phenomena, such as direct sunlight,
rain or snow.
Don’t use aggressive or abradant detergent for the device surface cleaning.
Use soft wet cloth or tissue to remove strong dirt.
Don’t overpower outlets. It can cause re or electric shock.
Nature protection
Don’t throw away the device with other industrial or nutritive trash if you see that
symbol. Some regions have separation and recycling systems for the electronic
equipment. Connect with local authorities to receive information about recycling of
electronic equipment for your region.
Rights and limitation of liability
All rights reserved. Any part of that document can not be published in any form, translated into other
languages or reproduced in any way including electronic or mechanical.
Document recording and copying is strictly denied without owner permission.
Table of contents
1. Package ............................................................................................................................................................................................3
2. Specication...................................................................................................................................................................................3
3. Description......................................................................................................................................................................................4
4. Installation.......................................................................................................................................................................................5
4.1 Cable requirements.......................................................................................................................................................5
4.2 Schematic diagram........................................................................................................................................................6
4.3 Unit mount .......................................................................................................................................................................7
5. Operation.........................................................................................................................................................................................8
5.1 Incoming call ...................................................................................................................................................................8
5.2 Outdoor panels image view.......................................................................................................................................9
6. Limited Warranty........................................................................................................................................................................10
!
UNIQUE
DIRECT
SERIES

{ Design. Uniqueness. Innovations }
3 4
Screen
Resolution
Video system
Audio type
Call time
Internal memory
Memory extension slot
Standby mode power consumption
Working mode power consumption
Power supply
Mounting type
Size
Working temperature
4,3”color TFT, 16:9
480×272 pixels
PAL/NTSC
Half duplex
120 seconds
No
No
1 W
6 W
Built-in power supply, AC100–240 V
Surface mount
119×175×21 mm (4.7×6.9×0.8 inch)
−10...+55 ˚C (14...131 ˚F)
1. Package
SQ-04 door monitor − 1 pc.
Wall mounting bracket − 1 pc.
Connection wires − 7 pcs.
Mounting screws and nuts − 1 pkg.
User manual − 1 pc.
2. Specication
3. Description
175 mm
(
6.9 inch)
1 19 mm (4.7 inch) 21mm
(0.8 inch)
1
2
3 4 5 6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
Display
Power switch
«Monitor» button – door panel or camera image monitoring
«Answer» button – incoming call answer and start talking with the visitor
«Unlock» button – door unlocking
«Hang Up» – stop conversation with the visitor
Microphone
Settings joystick :
• push the joystick while monitoring or talking to enter
brightness/contrast/chroma settings. Change current parameter by
pushing joystick again;
• move joystick up or down to change current parameter value
Ring volume tuning slider . Slide up to increase ring volume or down to decrease it
Talking volume tuning slider. Slide up to increase talking volume or down to decrease it
UNIQUE
DIRECT
SERIES

{ Design. Uniqueness. Innovations }
5 6
4.2 Schematic diagram
SQ-04 door panels and locks connection.
Power
Audio
GND
Video
Power
Audio
GND
Video
Lock
Doorbell 1
Doorbell 2
Lock power
supply
Lock Lock power
supply
4. Installation
4.1 Cable requirements
Disconnect all power cables before device installation.
This device can be connected with such cable types depends on the distance between door monitor and
door panel:
) Use 4-wire cable with such parameters:
• distance up to 25 meters (80 ft.) use a cable with 0,22 mm square of one wire (AWG24);
• distance 25 to 50 meters (80 to 160 ft.) use a cable with 0,41 mm square of one wire (AWG21);
• distance 50 to 100 (160 to 330 ft.) meters use a cable with 0,75 mm square of one wire (AWG18).
b) If the distance between door monitor and door panel is between 80 and 100 meters (260 and 330 ft.) then
use a 3-wire cable with 0,75 mmsquare of one wire (AWG18) and RG-59 or RG-6 coaxial cable for the video
signal.
c) Shielded or non-shielded twisted pair (not recommended):
• distance up to 25 meters (80 ft.) non-shielded twisted pair can be used;
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Power
Audio
Ground
Video
0 - 50 m 0 - 160 ft
Shield
Shield
50 - 80 m
80-100 m
RG-59 or RG-6
0 - 25 m
25 - 50 m
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Power
Audio
Ground
Video
Shield Shield
UNIQUE
DIRECT
SERIES
SQ-04
GND
+13,5 V
*
Door 1 Door 2
Power
Notes:
* Use «Power»connector on the monitor to connect external power
supply +13,5 V. While use external power supply please keep main power
cord ~100-240 V disconnected from the outlet, otherwise it can damage
monitor circuits.
** Door panels, power supplys and locks described on the scheme are
optional devices and aren’t included into monitors kit.
160 - 260 ft
260-330 ft
0-80 ft
80-160 ft

{ Design. Uniqueness. Innovations }
7 8
4.3 Unit mount
1) Take the surface mount bracket from the kit and place it 150-160 cm (approx. 5 ft.) from the oor line.
2) Mark and drill four halls in the wall.
3) Take four wall anchors from the kit and hammer them into the drilled halls.
4) Fix surface mount bracket on the wall by four screws from the kit.
5) Connect all communication wires and x the monitor on the surface mount bracket.
UNIQUE
DIRECT
SERIES
5. Operation
5.1 Incoming call
Standby mode
Standby mode
Melody is ringing on the
monitor and door panel,
image from the door panel
appears on the monitor screen
Visitor presses call button
on the rst door panel
Visitor presses call button
on the second door panel
Press «Answer» button to start
conversation with the visitor
Melody stops ringing and
conversation starts,
talking time is 120 seconds
Press «Hang up» button to
stop conversation or
incoming call
Press «Unlock» button to open
lock connected to the current
door panel, relay built into the
panel will open the lock
Notes:
1) Monitor will be automatically switched into standby mode if the user doesn’t answer incoming call
during 60 seconds;
2) Image and sound from the door panel will be active during 20 seconds after the moment user presses
button. It let the user know if the visitor passed through the door.
20 seconds

{ Design. Uniqueness. Innovations }
9 10
5.2 Outdoor panels image view
Standby mode
Monitor will display
the image from the
rst door panel
(monitoring time – 60 seconds)
Monitor will display
the image from the
second door panel
(monitoring time – 60 seconds)
Press «Monitor»
button on the
monitor
20 seconds
Standby mode
Press «Monitor»
button on the
monitor again
Press «Monitor»
button on the
monitor again
Press «Hang up» button to
stop monitoring or
conversation
Press «Answer» button to start
conversation with the visitor
Press «Unlock» button to open
lock connected to the current
door panel, relay built into the
panel will open the lock
UNIQUE
DIRECT
SERIES
6. Limited warranty
Manufacturer guarantees product normal functioning during the warranty period if the user keeps all safety
instructions described in that manual.
Warranty period is 12 months from the moment of the product purchasing (warranty period could be
extended up to 24 months or more, depending on the local regulations).
Warranty period allows user to make guarantee repair in cases when normal functioning of the product was
violated by the fault of manufacturer and the user haven’t oend transporting, installation and working
conditions.
This limited warranty does not cover any damage to the product that results from improper installation,
accident, abuse, misuse, natural disaster, insucient or excessive electrical supply, abnormal mechanical or
environmental conditions, or any unauthorized disassembly, repair or modication.
Warranty void in such cases:
• the product was damaged by the fault of the customer;
• the product wasn’t properly installed according reccomendations from the manual;
• the sticker on the backside of the product was broken;
• the product was not used for its intended function.
This limited warranty covers only repair, replacement, refund or credit for defective products, as provided
above. Manufacturer is not liable for, and does not cover under warranty, any damages or losses of any kind
whatsoever resulting from loss of, damage to, or corruption of, content or data or any costs associated with
determining the source of system problems or removing, servicing or installing products. This warranty
excludes third party software, connected equipment or stored data. Manufacturer is therefore not liable for
any losses or damage attributable to third party software, connected equipment or stored data.
In the event a product has been discontinued, manufacturer shall either repair the product, oer to replace
it with a comparable product or provide a refund at the lesser of the purchase price or the product’s current
value.
Repaired or replacement products will continue to be covered by this limited warranty for the remainder of
the original warranty term.
Notes:
If someone press call button on the door panel while monitoring is active then the image from this door
panel appears on the monitor screen and call melody starts. Press «Answer» button to start
conversation.