SLV 470805 User manual

controlled comfort
470805
Quick installation guide
TR
EL
FI
AR
PT
RU
ES
EN
HU
DE
v1.0 Quick installation guide

2
Read the “important information”
booklet before installing this product
Not following the safety instructions may
be dangerous and faulty installation will
invalidate any warranty that may apply to
this product.
EN HU
EL
DE

3
AR
RU
PT
TR
FI
ES

4
EN HU
EL
DE
1
Connect lamp/device and place
receiver
First check if the lamp or device is turned
on. Then plug the lamp or device into the
receiver and plug the receiver into a socket.
Do not exceed the maximum load: 3500 W.

5
AR
RU
PT
TR
FI
ES

6
1 sec.
EN HU
EL
DE
2
Activate learn-mode
Press the learn-button on the receiver
for 1 second. The learn-mode will be active
for 15 seconds, during which the LED-
indicator will blink slowly.

7
AR
RU
PT
TR
FI
ES

8
Assign SLV transmitter code
While the learn-mode is active, send
an ON-signal with any SLV CONTROL trans-
mitter to assign the code to the receiver’s
memory.
ON
EN HU
EL
DE
3

9
AR
RU
PT
TR
FI
ES

10
2x
EN HU
EL
DE
4
Code conrmation
The receiver will switch on/o 2 times
to conrm the code has been received.
The receiver can store up to 6 dierent
transmitter codes in its memory.
The memory will be preserved when the
receiver is moved to another socket or in
case of power failure.

11
AR
RU
PT
TR
FI
ES

12
Manual operation with a SLV
transmitter
(1) Press ON to switch the receiver on.
(2) Press OFF to switch the receiver o.
EN HU
EL
DE
5

13
AR
RU
PT
TR
FI
ES

14
1 sec.
OFF
2x
EN
Single code delete
ES PT
DE
Single code delete
(1) Press the learn-button for 1 second.
The learn-mode will be active for 15
seconds, during which the LED-indicator
will blink slowly. (2) While the learn-mode is
active, send an OFF-signal of a specic SLV
transmitter to delete that code.
(3) The receiver will switch on/o 2 times to
conrm code deletion.

15
AR
HU
FI
TR
RU
EL

16
7 sec.
1 sec.
2x
Full memory delete:
(1) Press and hold the learn-button
of the receiver (approx. 7 sec.) untill the
LED-indicator starts blinking fast. The
delete mode will be active for 15 seconds.
(2) While the delete mode is active, press
the learn-button again for 1 second. (3)
The receiver will switch on/o 2 times to
conrm memory deletion.
EN
Full memory delete
ES PT
DE

17
AR
HU
FI
TR
RU
EL