SMART SMART Board 500 Series User manual

Quick Reference
SMART Board™ Interactive Whiteboard Setup with Serial
Cable
The instructions below are for the SMART Board interactive whiteboard 500 series and apply to both desktop and
laptop computers.
Serial Port Keyboard
Port
Power Plug Socket
Keyboard Adapter
Keyboard Connector
Serial Cable
Long DB9
Connector
9-pin Serial Port
Short DB9 Connector
Ready Light
Connecting the SMART Board Interactive Whiteboard to Your Computer
1 To install SMART Board software, insert the CD-ROM that came with your SMART Board interactive
whiteboard and follow the on-screen instructions. If you don’t have a CD-ROM, or if you’re not sure whether
your CD-ROM is for the latest version of SMART Board software, download the most up-to-date version of the
software from http://www.smarttech.com/support/software/index.asp.
2 Shut off your computer. Do not remove the SMART Board software CD-ROM.
3 Insert the serial cable’s short DB9 connector into the 9-pin serial port under the lower-right side of the
interactive whiteboard and tighten the screws.
4 Insert the long DB9 connector (at the other end of the cable) into an available serial port on the back of your
computer and tighten the screws.
NOTE:If you’re connecting the whiteboard to a laptop, insert an external power supply into the back of the long
DB9 connector and skip to step 8.
5 Unplug your keyboard connector and reconnect it to the keyboard adapter.
6 Insert the male end of the keyboard adapter into the keyboard port on your computer.
7 Insert the power plug of the keyboard adapter into the back of the long DB9 connector that was connected in
step 4.
8 Turn on the computer. Verify the Ready Light on the right side of the SMART Pen Tray turns red to indicate
that the interactive whiteboard is on. If this light fails to turn red, verify that all connections are made as
indicated above.
9 When the Microsoft® Windows® operating system starts, a Found New Hardware wizard will appear. Follow
the on-screen instructions to search your hard drive for the SMART Board driver.

Selecting a COM Port
1 Click the SMART Board icon in the Notification Area at the bottom right of your screen, and
select Control Panel from the menu.
2 The SMART Board Control Panel will appear. Click the SMART Board Settings button.
SMART Board
Settings Button
3 Press the Add SMART Board button to scan your system for the interactive whiteboard.
Add SMART Board Button
4 After your SMART Board interactive whiteboard has been detected, press the OK button. The
Ready Light on the pen tray will turn from red to green, indicating that the interactive
whiteboard and the computer have established communication.
Orienting the SMART Board Interactive Whiteboard
You must orient the interactive whiteboard upon initial installation, or if your whiteboard or projector
has been moved or jostled. Ensure the projector, computer and SMART Board software are running.
1 Simultaneously press and hold the two SMART Pen Tray buttons.
Pen Tray Buttons
2 Begin orientation at the upper-left corner. Press your finger or pen squarely on the yellow
center of each red cross in the order specified by the white, diamond-shaped background.
3 If you’re dissatisfied with the precision of a particular orientation point, simply press the left
arrow key on the attached keyboard to redo a poorly aligned orientation point.
© 2005 SMART Technologies Inc. All rights reserved. SMART Board and the SMART logo are trademarks of SMART Technologies Inc. Microsoft and Windows are registered
trademarks of Microsoft Corporation in the United States and/or other countries. Printed in Canada 01/2005.