Solar Stik PRO-VERTER 7000-120 User manual

| 1April 2020 | Solar Stik®, Inc.
INSTRUCTION MANUAL
FOR
FILTER BOARD REPLACEMENT
ON THE
PRO-VERTER 7000-120
Version 1.0
Updated:20200410
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
P/N: 05-1000098

April 2020 | Solar Stik®, Inc.2 |
PRO-Verter 7000-120 Filter Board Replacement
Materials Included
• Replacement Filter Board for
PRO-Verter 7000-120
P/N: 05-1000098
Tools Required
• Torx T15 driver
• #2 cross-tip screwdriver
• #0 at-tip screwdriver
The Filter Board is shown below. Designations of orientation are with respect to the PRO-Verter.
BOTTOM SIDE
TOP
LEFT RIGHT
Safety
• Remove jewelry.
• Disconnect all power sources to the PRO-Verter such as batteries, Power Hubs, and generators.
Ensure all breakers and switches are in OFF position. If in doubt, please contact Solar Stik 24/7
Tech Support at 800-793-4364 Ext. 102.
• Use proper procedures and equipment to prevent damage from electrostatic discharge.

| 3April 2020 | Solar Stik®, Inc.
PRO-Verter 7000-120 Filter Board Replacement
1. Remove the twenty-two (22) fasteners around
the perimeter of the PRO-Verter Faceplate
(see orange circles, right) using a #2 cross-tip
screwdriver. Retain hardware for reinstallation.
2. Lift the left side of the PRO-Verter Facepalte
and swing it open to the right. Support
the Faceplate to prevent stressing wired
connections between the Facepalte and the
interor of the PRO-Verter.
The orange rectangle indicates the location of
the Filter Board.
3. Use a #0 at-tip screwdriver to press down
the release for the “HOT” and “NEUTRAL”
wires. Gently pull wires to remove. Label
wires to assist installation of replacement
board.
Note:
• Use a camera to document original installation conguration to facilitate reassembly.
• Label wires to reduce potential for misconnection during reassembly.

April 2020 | Solar Stik®, Inc.4 |
PRO-Verter 7000-120 Filter Board Replacement
4. Use a #0 at-tip screwdriver to press down
the release for the “START” and “FINISH”
wires. Gently pull wires to remove. Both
wires look the same. Label wires to assist
installation of replacement board.
5. Use a Torx T15 driver to remove the four (4)
mounting fasteners; one on each corner of
the board (orange circles). The fasteners are
long and pass through standoffs to connect
to the board below.
6. Lift the Filter Board out of the PRO-Verter. Reverse steps 1–5 to install the replacement Filter
Board.
START
FINISH
StandoffsFasteners