Solar Stik PRO-VERTER 5000-240 User manual

| 1April 2020 | Solar Stik®, Inc.
INSTRUCTION MANUAL
FOR
FILTER BOARD REPLACEMENT
ON THE
PRO-VERTER 5000-240
Version 1.0
Updated:20200410
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
P/N: 05-1000108

April 2020 | Solar Stik®, Inc.2 |
PRO-Verter 5000-240 Filter Board Replacement
Materials Included
• Replacement Filter Board for
PRO-Verter 5000-240
P/N: 05-1000108
Tools Required
• Torx T15 driver
• #2 cross-tip screw driver
The Filter Board is shown below. Designations of orientation are with respect to the PRO-Verter. Note
the name of the connectors on the board.
LEFT RIGHT
Note:
• Use a camera to document original installation conguration to facilitate reassembly.
• Label wires to reduce potential for misconnection during reassembly.
Safety
• Remove jewelry.
• Disconnect all power sources to the PRO-Verter such as batteries, Power Hubs and generators.
Ensure all breakers and switches are in OFF position. If in doubt, please contact Solar Stik 24/7
Tech Support at 800-793-4364 Ext. 102.
• Use proper procedures and equipment to prevent damage from electrostatic discharge.

| 3April 2020 | Solar Stik®, Inc.
PRO-Verter 5000-240 Filter Board Replacement
1. Remove the twenty-two (22) fasteners
around the perimeter of the PRO-Verter
Faceplate (see orange circles, right) using a
#2 cross-tip screw driver. Retain hardware for
reinstallation.
2. Lift the left side of the PRO-Verter Faceplate
and swing it open to the right. Support
the Faceplate to prevent stressing wired
connections between the Faceplate and the
interior of the PRO-Verter.
The orange rectangle indicates the location of
the Filter Board.
3. Label each of the four (4) wires on the left
side of the Filter Board. The four (4) white
wires on the right side are already labeled
(e.g., S1=Start 1, F1=Finish 1). Disconnect the
labeled wires.

April 2020 | Solar Stik®, Inc.4 |
PRO-Verter 5000-240 Filter Board Replacement
4. Use a Torx T15 driver to remove the four (4)
mounting fasteners, one on each corner of
the board (orange circles). The fasteners are
long and pass through standoffs to connect
to the AC Board below.
5. Lift the Filter Board out of the PRO-Verter. Reverse Steps 1–4 to install the replacement Filter
Board.
StandoffsFasteners
The Filter Board, standoffs and fasteners