SOMFY 9010217 User manual

External Li-ion Battery Pack Quick Guide
Copyright © Somfy SAS 8/2020 P-0060CBG
www.somfysystems.com
BEFORE YOU BEGIN:
• Be certain you have the correct Somfy plug-in charger for your
battery pack (see Ref/fig below #9025166)
• Battery should be charged completely prior to installation.
• Ensure you comply with the recharging instructions.
The optimum recharging temperature is between 32°F and 113°F.
• Do not disassemble or alter the battery.
• Must only be used with Somfy External Battery WireFree motors
(refer to the motor instructions for programing).
• Do not use or install this product outdoors.
• Product must never be dropped, immersed in water or exposed
to flammable materials.
• Battery pack should always be replaced with Somfy certified replacement.
External Li-ion Battery Pack # 9010217
items included:
1 Battery (above)
(1 Pair) of Wall/Ceiling mount Brackets
(1 Pair) of Headrail mount Brackets
(1 Pair) of screws and mounting anchors
MOUNTING METHODS:
A) With a wall/celilng bracket B) With a headrail mount bracket
Charger with 6ft. Cable
#9025166
8” Charger Extension Cable
#9021131
(Wood & Fauxwood Blinds only)
94.5” Charger Extension Cable
#9021016
Motor Extension Cables
10” - #9018623
48” - #9016736
96” - #9018624
Accessories:

www.somfysystems.com
Copyright © Somfy SAS 8/2020 P-0060CBG
NOTE:
In tubular motors with LED indicator on
the motorhead red blinking light indicates
low battery.
STEP 1
If battery pack charging port is
accessible simply plug charger
into battery pack charging port
(see fig.1) and skip to STEP 4.
If battery charging port is not
accessible, follow STEP 2.
STEP 2
Disconnect battery pack
cable connector from motor
cable connector, then simply
remove battery pack from
brackets to charge.
STEP 3
Attach small connector from
wall charger to charging port
of battery pack.
STEP 5
Once LED illuminates
GREEN, battery is fully
charged.
Disconnect wall charger
connector from battery
charging port, then remove
wall charger from electrical
outlet.
STEP 6
If battery was removed from
brackets for charging, simply
reinstall battery pack into
mounting brackets.
STEP 7
Reconnect battery pack cable
connector to motor cable
connector.
STEP 8
Manage the placement of all
cords making certain they do
not interfere with movement
of window covering. Be certain
motor antenna is exposed for
optimal radio performance.
Quick Guide to charging Li-ion battery pack
NOTE: Using battery charging accessory (Ref. 9021131 or 9021016 )
illustrated above can facilitate access to the battery pack charging port.
Charging Port
Connection
to Motor
Fig. 1
5x
STEP 4
Plug Wall charger into a
nearby electrical outlet. The
LED indicator will illuminate
RED while battery is charging.