Sonel KT-320 User manual

page 1
Live video setup
Quick guide
v1.00 | 20.04.2020
Enable
USB Video
in the camera
►
Connect
the camera
to the PC
►
Set up an IP
►
Install
video driver
►
Run Sonel
ThermoAnalyze2
During the whole process, after connecting the camera to the PC via USB in step ,
do not disconnect it –otherwise re-connection is required. In case of need of re-
connection, please first choose No in step , then Yes and connect the camera
again. Only then the PC can recognize the device correctly.
Turn on the camera. Go to System setting ►USB Video and select Yes.
►
Connect the camera to the PC using USB cable.

page 2
Expand network list ( or ).
Click Network & Internet
settings.
Choose Change adapter options.
Right-click Ethernet4 (Kindle USB RNDIS Device) and choose Properties.

page 3
Double-click Internet Protocol
Version 4 (TCP/IPv4).
Set IP address and mask as below and confirm. The third part of IP address should be 42. The
fourth part should never be 29 since the fourth part in camera IP address is 29. Click OK.
►

page 4
Now install the USB driver. Open folder kindle_rndis.inf_amd64.
Right-click 5-runasadmin_register-CA-cer and run it as administrator.
If the console displays messages as below, the operation was successful. Close the window.

page 5
Go to device manager (Desktop ►right-click on the computer icon ►Management). If the
Kindle USB RNDIS Device (USBNetwork enabled) is not detected properly (an unknown USB
device is visible), right-click it and choose Update driver.
Click Browse my computer for driver software and then Browse.
►
Select kindle_rndis.inf_amd64 and click Yes. Then click Next and finish the installation.
►

page 6
Run Sonel ThermoAnalyze2. Click Video, select KT-170/400, then USB and click Confirm.
Live video is now available.