Printed in Japan on recycled paper
MK7465V1OHB99OCT
Distributed by
FEATURES
FEATURES
■High-resolution 1280 dots x 608 lines printing (in WIDE 2 scan mode) and
256 steps of gray level
■12.8 dpm or 325 dpi print resolution
■High quality, glossy, near photographic printing with newly developed
printing paper, UPP-110HG
■Smoothing feature for smoother, clearer image output
■Automatic selection of EIA/CCIR video signal
■Worldwide power supply for AC 100 to 120 / 220 to 240 V
■Automatic paper load system for simple operation
■Multiple copies (up to a maximum of ten)
■Audible alarm when printer needs paper or the video signal is absent
■Compact and lightweight
■Fast printing of approximately 3.9 seconds per screen (with smoothing
feature turned off and printer set to STANDARD print mode)
■Thermal head protection
■Wide scanning function (NORMAL/WIDE 1/WIDE 2)
■2x zoom for either half of picture in either STANDARD or SIDE mode
■Approx. 201 prints* out of UPP-110HG (18 m)**
*Approx.193 prints when each image cut out
**In default setting
SPECIFICATIONS
SPECIFICATIONS
Front panel Rear panel UPP-110HG
PRINT MODES
PRINT MODES
Standard Side
2x zoom
Small
Normal
©1999 Sony Corporation. All rights reserved.
Reproduction in whole or in part without written permission is prohibited.
Features and specifications are subject to change without notice.
All non-metric weights and measures are approximate.
Sony is a registered trademark of Sony Corporation.
Thermal head: Thin film thermal head, 1280 dots
Gradations: 256 steps of gray level (quasi)
Printed picture size: STANDARD print mode, at 4:3 aspect ratio
(EIA) NORMAL: 90 x 69 mm
(3 5/8 x 2 3/4 inches)
WIDE1: 94 x 72 mm
(3 3/4 x 2 7/8 inches)
WIDE2: 100 x 74 mm
(4 x 3 inches)
(CCIR) NORMAL: 90 x 68 mm
(3 5/8 x 2 3/4 inches)
WIDE1: 94 x 71 mm
(3 3/4 x 2 7/8 inches)
WIDE2: 100 x 74 mm
(4 x 3 inches)
Effective pixels: STANDARD print mode, at 4:3 aspect ratio
(EIA) NORMAL: 1150 dots x 472 lines
WIDE1: 1210 dots x 490 lines
WIDE2: 1280 dots x 508 lines
(CCIR) NORMAL: 1150 dots x 560 lines
WIDE1: 1210 dots x 582 lines
WIDE2: 1280 dots x 608 lines
Printing speed: Approx. 3.9 seconds/screen
(STANDARD print mode, smoothing off)
Approx. 6.8 seconds/screen
(SIDE print mode, smoothing off)
Approx. 7.8 seconds/screen
(STANDARD print mode, smoothing on)
Picture memory: 8-bit frame memory
Input/Output: VIDEO IN: BNC, EIA or CCIR composite
video signal, 1.0 Vp-p,
75 Ω/high impedance selectable
VIDEO OUT: BNC, Loop through or
E to E selectable
Remote: Stereo mini jack for an optional Foot
Switch FS-20 and Remote Control Unit
RM-91
Power requirements: AC 100 to 120 V/ 220 to 240 V, 50/60Hz
Power consumption: Max. 120 W
Dimensions: Approx. 154 (W) x 105 (H) x 260 (D) mm
(6 1/8 x4 1/4 x 10 1/4 inches)
Mass: 3.4 kg (7 lb 8 oz)
Supplied accessories:
AC power cable
BNC cable (1.5 m)
Printing paper roll (UPP-110HG)
Head-cleaning sheet
Operation manual
Consumables: High Quality Printing Paper UPP-110S
(110 mm x 20 m)
High Density Printing Paper UPP-110HD
(110 mm x 20 m)
High Glossy Printing Paper UPP-110HG
(110 mm x 18 m)
Optional accessories:
Foot Switch FS-20
Remote Control Unit RM-91
Safety regulations: UL-1950, CSA No.22.2, No.950
EMC regulations: FCC ClassA, ICES003
