3
SRF-HM03V
SECTION 1
GENERAL This section is extracted from
instruction manual.
POWER ON/OFF
Driver Unit
TUNE +*2/—
Display
MEGA BASS/CLOCK ENTER
MODEBAND
VOL*1
TV/WB/FM SENS
DX/LOCAL
R(Right)
L(Left)
Battery
compartment lid
Light reflector (L)
This reflector
reflects car lights
at night for your
safety.
*1There is a tactile dot beside volume to show the
direction to turn up the volume.
*2The TUNE + button has a tactile dot.
Setting the Clock
The clock time display of this unit is a 12-hour system.
When the battery is first installed, AM 12:00 flashes in the display.
1
Set POWER to OFF to turn off the power.
2
Hold down MEGA BASS/CLOCK for more than 2 seconds
until AM 12 starts flashing.
3
Press TUNE + or –to adjust the hour, then press MEGA BASS/
CLOCK.
If you hold down TUNE + or —, the digit changes rapidly.
AM 12:00 = midnight, PM 12:00 = noon.
4
Repeat step 3above to adjust the minute.
: starts flashing and the clock starts operating.
To set the current time exactly to the second, adjust the minute and then press
MEGA BASS/CLOCK to synchronize with a time signal (such as the
telephone time signal).
Note
If you do not press TUNE + or —, or MEGA BASS/CLOCK within one minute,
the clock setting mode will be canceled.
Wearing the Headphone
Radio
(See fig A)
1
Wear the Lside driver unit in your left ear and the Rside in your
right ear as illustrated.
2
Adjust the position of the driver units for a comfortable fit.
Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is
factory-set to 10 kHz. Change the settings as shown below to be able to listen to
the radio.
Area Channel step
North and South American countries 10 kHz
Other countries 9 kHz
Note
When the AM channel step is changed, only the preset stations on the AM band
will be initialized.
1
Set POWER to OFF to turn off the power.
2
While holding down MODE, hold down TUNE + or –for more
than 5 seconds.
The channel step will change and 9 kHz (or 10 kHz) will flash for 3
seconds in the display.
If you proceed to step 2again, the channel step changes again.
Light reflector (R)
A
