Sound Tube RF31-EZ-T Configuration guide

Do not spec or install speaker near support beam, ventilation duct or
other structure that may interfere with speaker function or dispersion.
Warning Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for
optimum audio performance, installer must follow all directions issued by SoundTube Entertainment.
Grille
Grillesafetyclip
Screws
Speaker
Two-gangjunctionbox (installer supplied)
NOTE: the RF31-EZ-T is designed to install
into a standard 2-gang junction box.
SoundTube recommends you test the fit
before installing the junction box.
Paintmask
Box contents
1 Speaker
1 Grille
1 Paint mask
4 Mounting screws
© 2010 SoundTube Entertainment, Inc. All rights reserved. PN INS-RF-31-T Rev 09.7.10
Optional Accessories
Theft-resistant, stainless steel
grille (AC-RF31-TRG)
Install Instructions For:
RF31-EZ-T speaker
RF31-EZ-T

1. Unpack speaker.
RF31-EZ-T Installation Instructions For:
RF31-EZ-T speaker
1.435.647.9555 |800.647.TUBE | www.soundtube.com
1.
2.
5. Attach grille safety clip
by placing the large end of
the clip over snap-fit post
(1), then sliding clip until
small end snaps into place
around post (2).
2. Connect signal wires to
speaker using terminal
block. Connect - wire to "C".
Connect + wire according
to step 2a.
3. Install the RF31-EZ into
the installer-supplied
junction box using included
fasteners. Note: for best
performance, make sure
that junction box is well
sealed.
7. Done!
2a. Terminal Settings
Terminal
Ground Ground Ground
C
1
2
3
4
100v 70.7v 25v
X
10w
5w
2.5w
10w
5w
2.5w
1.3w
1.3w
0.7w
0.4w
0.2w
6. Align tabs on snap-fit
grille with slots in baffle,
gently press grille into place.
4. If space isn't yet finished,
apply paint mask to protect
RF31. Remove when finish
work is complete.