SpectraLink Handset User manual

Product End-of-Life Disassembly Instructions
1
Disassembly Instructions Form Doc # | Spectralink Europe ApS
This document is intended for use by end-of-life recyclers or treatment facilities. It provides the basic
instructions for the disassembly of Spectralink Butterfly Handset to remove components and materials
requiring selective treatment, as defined by EU Directive 2002/96/EC Waste Electrical and Electronic
Equipment (WEEE).
Product Name : Handset / Spectralink Butterfly Handset
Items Requiring Selective Treatment
The following components should be disposed of or recovered separately from other recyclable items, in compliance
with Article 4 of EU council Directive 75/442/EEC
Enter the quantity of items below contained within the product in the right column, as applicable.
Item Description
Notes
Quantity in
product
Printed Circuit Boards of Printed
Circuit assemblies
With surface greater than 10 sq cm
1
Batteries
Ni-MH rechargeable batteries, type AAA
1.2V
2
Mercury Containing components
For example, mercury lamps, display
backlights, scanner lamps, switches,
batteries
No
Liquied Crystal Displays (LCD) with
a surface greater than 100 sq cm
Includes background illuminated displays
with gas discharge lamps
No
Cathode Ray Tubes
No
Electrolytic capacitors / condensers
Measuring greater than 2.5 cm diameter or
height
No
External electrical cables and cords
No
Gas Discharge lamps
No
Plastics containing brominated
flame retardants weighing >26g
Does not include PCBs or PCSs
No
Components and parts containing
toner and ink
No
Parts and materials containing
refractory ceramic fibers
No
Tools required to disassemble the product where components and materials in table above can be
removed.
Tool Description
Tools Size (if
Applicable)
Phillips Screwdriver
Tx 6

Product End-of-Life Disassembly Instructions
2
Disassembly Instructions Form Doc # | Spectralink Europe ApS
Disassembly Instructions
The main points to consider when disassembling this product/assembly are:
1. To remove the battery cover, use the small opening on top of the handset. Use a paperclip or a wide
screwdriver. When the gap at the top opens, lift off the battery cover.
2. Remove the batteries.
3. Remove the 6 screws (with TX 6) and seperat the cover from the bottom.
4. Take PCB out of the housing.
5. Dispose separately the batteries and the PCB.
Figure 1- Open the battery cover

Product End-of-Life Disassembly Instructions
3
Disassembly Instructions Form Doc # | Spectralink Europe ApS
Figure 2 –Remove the batteries
Figure 3 –Remove the screws

Product End-of-Life Disassembly Instructions
4
Disassembly Instructions Form Doc # | Spectralink Europe ApS
Figure 4 –Remove the PCB

Product End-of-Life Disassembly Instructions
5
Disassembly Instructions Form Doc # | Spectralink Europe ApS
Figure 5 –KIRK Butterfly components