Spinmaster COOL MAKER User manual

VISIT:
www.coolmaker.com
+
8
YEARS
AIRBRUSH STYLING STUDIO
Check Out
For How-To
Videos!
@coolmaker
BATTERIES
NOT INCLUDED
xA A
2

02
IMPORTANT: For indoor dry locations use only.
Clean the product with a dry cloth only. Do not
store or use product near heat, sparks or flame.
BATTERY SAFETY INFORMATION: Batteries are
small objects. Replacement of batteries must
be done by adults. Follow the polarity (+/-)
diagram in the battery compartment. Promptly
remove dead batteries from the toy. Dispose
of used batteries properly. Remove batteries
for prolonged storage. Only batteries of the
same or equivalent type as recommended are
to be used. DO NOT incinerate used batteries.
DO NOT dispose of batteries in fire, as batteries
may explode or leak. DO NOT mix old and new
batteries or types of batteries (i.e. alkaline/
standard/rechargeable). Using rechargeable
batteries is not recommended due to possible
reduced performance. Rechargeable batteries
are only to be charged under adult supervision.
Replaceable-rechargeable batteries are to be
removed from the toy before being charged. DO
NOT recharge non-rechargeable batteries. DO
NOT short-circuit the supply terminals.
Requires 2 x AA 1.5 V (LR6)
batteries (not included).
Batteries or battery packs
must be recycled or
disposed of properly. When
this product has reached
the end of its useful life it should not be disposed
of with other household waste. The Waste
Electrical and Electronic Equipment Regulations
require it to be separately collected so that it
can be treated using the best available recovery
and recycling techniques. This will minimize
the impact on the environment and human
health from soil and water contamination by any
hazardous substances, decrease the resources
required to make new products and avoid using
up landfill space. Please do your part by keeping
this product out of the municipal waste stream!
The “wheelie bin” symbol means that it should
be collected as “waste electrical and electronic
equipment”. You can return an old product to your
retailer when you buy a similar new one. For other
options, please contact your local council.
BATTERY INFORMATION

03
HOW TO INSTALL BATTERIES:
Ensure machine is in OFF position.
1. Open the battery door with a
screwdriver. 2. If used batteries are
present, remove these batteries from
the unit by pulling up on one end of
each battery. DO NOT remove or install
batteries using sharp or metal tools.
3. Install new batteries as shown in
the image (+/-) inside the battery
compartment. 4. Replace battery door
securely. 5. Check your local laws and
regulations for correct recycling and/
or battery disposal.
BATTERY INFORMATION
Battery
Compartment:
*Requires 2 AA
(LR6) Batteries
Not Included.

04
*ING REDIENTS: WATER/AQUA, GLYCERIN, POTASSIUM
SORBATE, [+/- (MAY CONTAIN): BLUE 1 (CI 42090),
RED 40 (CI 16035), YELLOW 6 (CI 15985)]
1 Cool Maker™ Styling Model
5
Style Sticks 5 x 0.03 oz (0.85g)
*
1 Cordless Airbrush
2 Clip in Extensions
2 Sheets of Makeup Stencils
2 Sheets of Hair Stencils
4 Hair Elastics
2 Hair Clips
1 Sheet of Eye Color Stickers
24 Gems
1 Hairbrush
1 Makeup Erasing Sponge
1 Lookbook
1 Playbook
CONTENTS

05
Diagram:
Style Stick
Start/Stop Trigger
Spray Nozzle
ON/OFF Switch
DIRECTIONS FOR USE: Do not use markers with this product other than Cool Maker™ style sticks.
DIAGRAM
Removeable
base to store
materials.
AIRBRUSH MODEL
*Requires 2 AA
(LR6) Batteries
Not Included.

06
Remove cap and insert style
stick, tip first, into top of
airbrush.
2
Push style stick in until you
feel a click.
3
Hold the airbrush
on an angle with
the tip 2 finger
widths away from
a scrap piece
of paper. Gently
squeeze the trigger
and practice
spraying.
4
AIRBRUSH
1
ON OFF
How to Use
Airbrush:
Push switch to
turn ON and OFF.
Keep switch OFF
until ready to
spray.

07
AIRBRUSH
* Remember, hold airbrush nozzle 2 finger
widths from surface.
Tips &
Techniques:
• Before getting started, cover play surface
to avoid mess.
• Gently pull style stick out of airbrush and
recap after use to avoid drying out.
• Try spraying in short bursts to get even coverage.
• Try not to spray continuously as the ink might run.
• Turn off when not in use to avoid spraying
accidentally.
DO NOT spray airbrush directly against surface.
Important: Do not apply the style sticks at people and
animals. Do not aim at eyes or face.

HAIR HIGHLIGHTS
08
Brush all hair root to tip.
Hold section
of hair by
ends, (away
from model)
and spray
back and
forth until
desired color
appears.
1
2
3
4
Hair
Highlights
TIP 2: Brush hair
after highlighting
for a softer, more
natural look.
TIP 1: Highlight white
hair for best color
results.
Style hair.
Change colors
for different
sections of hair!

09
HAIR STENCILS
Press stencil against hair and spray.
4
Hair
Stencils
Brush all hair
root to tip.
TIP: Keep hand holding stencil
very steady while spraying.
Please refer to page 6 for Airbrush setup.
Gently separate stencil on
perforation and punch out shape.
2
For best results, use hair clip to
keep stencil area in place.Avoid
using stencils on loose hair.
3
1
Check Out
@coolmaker
for How-To Videos!

10
MAKEUP STENCILS
TIP: To reuse, place sticker stencil
back on backing and wipe excess
marker off stencil with papertowel.
Peel back sticker stencil ensuring full
design is popped out. Save backing.
Gently spray short bursts two finger
widths from stencil. Avoid spraying too
much, as stencil may be ruined.
13
Firmly press on the design
cut-out. The outside edge of
the stencil does not need to
be stuck down.
2
Refer to page 6 for Airbrush setup.
See Lookbook for design ideas.
DO NOT spray airbrush directly
against surface.
OUTSIDE
EDGE
DESIGN CUT-OUT