Spinmaster Hyper Actives Stunt User manual

M
Contents:
• 1 x Hyper Actives Stunt™
• 1 x Controller/Charger
• 1 x Instruction Guide
®
1. Open the battery door with a
screwdriver (not included).
2. If used batteries are
present, remove these
batteries from the unit by
pulling up on one end of
each battery.
3. Install new batteries as
shown in the polarity
diagram (+/-) inside the
battery compartment.
4.eplace battery door
securely.
5. Check your local laws
and regulations for correct
recycling and/or battery
disposal.
INS ALLING/REPLACING HE BA ERIES
HOW O CHARGE YOUR HYPER AC IVES S UN ™
USING HE CON ROLLER/CHARGER
Battery
Compartment
Cover
Battery
Compartment
6 x
1.5V AA
Alkaline
Batteries
• Controller/charger requires
6 x 1.5V AA alkaline
batteries (not included).
• Batteries are small objects.
• eplacement of batteries
must be done by adults.
• Follow the polarity (+/-)
diagram in the battery
compartment.
• Promptly remove dead
batteries from the toy.
• Dispose of used batteries
properly.
• emove batteries for
prolonged storage.
• Only batteries of the same
or equivalent type as re-
commended are to be used.
• DO NOT incinerate used
batteries.
• DO NOT dispose of
batteries in fire, as batteries
may explode or leak.
• DO NOT mix old and new
batteries.
• DO NOT mix different types
of batteries, i.e.: alkaline/
standard (carbon-zinc) or
rechargeable batteries.
• DO NOT use rechargeable
batteries.
• DO NOT recharge
non-rechargeable batteries.
• DO NOT short-circuit the
supply terminals.
• DO NOT store your car
or controller near heat or in
direct sunlight.
BA ERY SAFE Y INFORMA ION
Left/ ight
8-10YRS
O
CHG OFF ON
CHG OFF ON
1. Turn vehicle OFF.
2. Turn controller/charger OFF.
3. Open charge door to access
charge cable.
4. Open charge port cover located
on the side of the vehicle.
5. Carefully push the charge plug
all the way into the vehicle’s
charge port.
6. Set the controller/charger switch
to CHG.
7. The red charging light will turn
on and charging will begin when
it starts to flash. After 30 to 50
minutes the charging will be
complete and the red charge
light and green power light will
both start to flash.
8. When charging is complete,
turn controller/charger OFF.
9. Carefully remove the
charge plug from the vehicle’s
charge port.
10. Close the charge port cover.
11. Wrap charge cable starting
at tab indicated then close
charge door.
CHG OFF ON
1
4
8 9 10 11
5 6 7
2 3
INS RUC IONS
Controller/Charger
Hyper Actives
Stunt™
Forward/
everse Power Light
Charge Light
CHG/OFF/ON
Switch
Spin Button
Turbo Button
Cover and
Charge Cable
Impact
Bumper
Charge
Port
ON/OFF
Switch
Over-sized
Tires
Forward/Reverse, Left/Right
1. Turn vehicle ON.
2. Turn controller/charger ON.
3. The left stick controls
the vehicle’s forward and
reverse driving.
4. To move the vehicle to the right
push the right stick to the right.
5. To move the vehicle to the left
move the right stick to the left. 4 5
1
CHG OFF ON
2 3
T
rim Knob
NO E: 1. If the charge light and power light are flashing alternatively while
charging, there may be a bad cable connection. Check that cable and plug
are connected correctly and repeat charging steps 1 to 6.
2. The remote control will automatically shut off after idling for about
5 minutes. To reactivate turn off and on.
3. When the remote control is in either ON status or CHARGE status and
the green power light is flashing, it means that the battery level is low
and the batteries need to be replaced.
WARNING:
CHOKING HAZARD – Small parts.
Not for Children under 3 years.

Contains LiPo battery pack. • Battery pack must be recycled or disposed of properly.
• If at any time in the future you should need to dispose of this product please note
that Waste Electrical Products should NOT be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer for
recycling advice. (Waste Electrical and Electronic Equipment Directive).
Warning:
CHOKING HAZARD –
Small Parts.
Air Hogs®, related trademarks & © 2011 Spin Master td. All rights reserved. This
product conforms to safety requirements of ASTM F-963, EN-71 & CHPA. • Please retain
this information for future reference. • Please remove all packaging materials before
giving to children. • An adult should periodically check this toy to ensure no damage
or hazards exist, if so, remove from use. • Children should be supervised during play.
• Keep addresses and phone numbers for future reference. • The item inside this
package may vary from the photographs and/or illustrations. MADE IN CHINA.
20037619, 20037620 GEN REV 0
T20416_0002_20037619_GEN_IS_R1
Spin Master td., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Customer Care: 1-800-622-8339 Fax: [phone]
Email: [e-mail]
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville,
NY 14221, USA
Spin Master Toys Far East imited, Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
SPIN MASTER INTERNATIONA , S.A.R. ., 16 AVENUE PASTEUR, -2310, UXEMBOURG
www.spinmaster.com
ROUBLESHOO ING GUIDE
Vehicle is slow or will not move.
Vehicle does not drive in a
straight line.
My vehicle and/or controller is dirty.
Vehicle is not responding or driving
on it’s own.
1. Batteries in the controller need to be
replaced if green power light is flashing.
2. Vehicle is out of range of controller.
3. There is hair or debris stuck in the wheels
or wheel axles.
4. Batteries are installed incorrectly.
5. Improper surface for vehicle.
6. Controller not aimed at vehicle or
objects interfering with signal.
7. Controller was inactive for 30 seconds
or more and turned itself off to preserve
your batteries.
Vehicle requires wheel alignment.
1. Inappropriate driving surface.
2. Dirty hands.
1. Using another vehicle controller/
charger of the same frequency.
2. Infrared interference from another source.
3. Bright lights may be affecting the
I control.
1. eplace batteries in the controller with new, fresh batteries.
2. Move closer to the vehicle.
3. With the vehicle and controller turned off, have an adult carefully remove the hair
or debris from the wheels or wheel axles.
4. With the vehicle and controller turned off, have an adult check that the batteries
are installed correctly in the controller.
5. Indoor play only on hard surfaces. Examples of poor play surfaces are thick
carpet, grass or sand. Examples of good play surfaces are non-carpeted floors,
flat tile floors or flat wooden floors.
6. Point controller I at the vehicle. Ensure there are no objects blocking the
controller “line of sight” to the vehicle.
7. e-set both vehicle and controller OFF to ON.
efer to Trim Adjustment guide above.
Ensure the controller and vehicle are off. Have an adult remove the
batteries first and replace the battery cover. Slightly dampen a clean cloth in water
and wipe toy clean. Wipe dry. DO NOT IMME SE IN WATE and DO NOT USE
ANY CHEMICALS. Let the toy completely dry before putting batteries back into
clean, dry battery compartment.
1. Only use the controller/charger supplied with this vehicle.
2. Do not operate vehicle around devices that emit other infrared signals.
3. Avoid driving near windows or bright lights or choose another place to operate
the vehicle.
PROBLEM CAUSE SOLU ION
NO E: If normal function of the product is disturbed or interrupted, strong
electro-magnetic interference may be causing the issue. To reset product, turn it
completely off, then turn it back on. If normal operation does not resume, move the
product to another location and try again. To ensure normal performance, change
the batteries, as low batteries may not allow full function.
Your Hyper Actives Stunt™ is e uipped with a Lithium Polymer battery.
SPECIAL LIPO BATTERY INSTRUCTIONS:
• Never charge battery unattended. • Charge battery in isolated area. Keep away from
flammable materials. • Do not expose to direct sunlight. • There is a risk of the batteries
exploding, overheating, or igniting. Do not disassemble, modify heat, or short-circuit the
batteries. Do not place them in fires or leave them in hot places. • Do not drop or subject to
strong impacts. • Do not allow the batteries to get wet. • Only charge the batteries with the
specified Spin Master™ battery charger. • Only use the batteries in the device specified by
Spin Master™. • Carefully read the instruction guide, and use the batteries correctly. • In the
unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery.
• Batteries must be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed, product disassembly
and battery removal must be performed by an adult. Do not use any tools for disassembly. Pulling, tearing,
and deforming of the product during disassembly, while necessary, should be as limited as possible. Do not
compress the product at any time. Ensure product is turned off. Find a point where the two body halves
meet; the front or back or sides of the vehicle. Start to peel the halves apart, separating them where they are
glued together; remove any tape as necessary. Separate product body halves to expose internal electronics.
To separate battery from product use scissors to cut a single battery wire, immediately wrap the cut wire
end with tape to isolate it, repeat until all battery wires are cut and isolated. Dispose of battery in accordance
with your local battery recycling or disposal laws. NOTE: Opening of product and/or removal of battery will
render product inoperative and voids manufacturer warranties, dispose of remaining product components in
accordance with local laws.
VEHICLE RIM ADJUS MEN
PERFORMING SPINS
ONCE YOU’RE FINISHED PLAYING
If the vehicle is not driving
straight when you push the
forward/reverse stick forward,
use the trim knob to correct
the problem.
1. If the vehicle turns to the left,
slowly turn the trim knob to
the right until the vehicle
drives straight.
2. If the vehicle turns to the
right, slowly turn the trim knob
to the left until the vehicle
drives straight.
Pressing the spin button while the
vehicle is moving/accelerating causes
the vehicle to spin. In some cases,
depending in speed, direction and
surface condition the vehicle may flip
over. Because the vehicle can run on
either side you can just keep driving.
O
CHG OFF ON
URBO ACCELERA ION
Pressing the turbo
button increases
the speed of the
vehicle.
1
2
Turn vehicle OFF.Turn controller/charger OFF.
M
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference to radio communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that
interference will not occur. If not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this toy does cause interference to radio or television reception (you can
check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy
and the radio or the TV • Consult the dealer or an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component
(crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master td. or they could void the user’s authority to operate the equipment.
CANADIAN Class B statement: This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.