
10 1-800-732-0144
GENERAL TRAINING TIPS
BEFORE TRAINING YOUR DOG WITH THIS PRODUCT
You will have the most success using this Remote Trainer if you always remember to teach a command before
trying to reinforce the command with the Remote Trainer. Always keep the following training tips in mind:
• Eliminate one misbehavior or teach one obedience command at a time. If you move too fast with the training,
your dog may become confused.
• Be consistent. Give your dog a static, tone, or vibration stimulation with each misbehavior.
• Do not over-stimulate your dog. Use as few stimulations as possible to train your dog.
• Restrict your dog from situations in which he has a history of misbehaving unless you can supervise him and
use the Remote Trainer for applying static, tone, or vibration stimulation.
• If you notice one situation in which your dog misbehaves repeatedly, set up this situation as a training session.
This will dramatically increase your chances of success.
• If your dog has a timid reaction to the static, tone, or vibration stimulation (especially the first couple of times),
do not be alarmed. Redirect his attention to a simple and appropriate behavior (i.e. a known command, such as
“Sit”).
• Never use the Remote Trainer to correct or eliminate any form of aggressive behavior. If your dog exhibits such
behavior, contact a professional trainer. Aggression in dogs is the result of many factors. It may be a learned
behavior or it may be brought on as a result of fear. Another factor contributing to aggression in dogs is social
dominance. Every dog is different.
Visit our website at www.sportdog.com to find more detailed training tips and guides, or contact our Customer
Care Center for further assistance.
At this point, your Remote Trainer is ready to use. The Remote Transmitter is factory set to Mode 1, but you may
wish to change the mode to fit your situation. See STEP::05 for an explanation of mode options.
STEP::05
PROGRAM THE REMOTE TRANSMITTER
The SportTrainer™575 Remote Transmitter has two operational modes allowing you to select the best match for
your type or style of training. NOTE: The Remote Transmitter is factory set to Mode 1.
TO CHANGE THE MODE:
1. Refer to the table below to review the available modes.
2. Using the Intensity Buttons (-/+), set the display to 1.
3. Turn the Remote Transmitter over and remove the belt clip
(if attached). Using a pen or the tine of a buckle, depress and
release the Mode Button.
4. Using the Intensity Buttons (-/+), set to Mode 1 or 2. After 5
seconds, your selected mode will flash to indicate that it has
been set.
MODE # LEFT BUTTON TOP RIGHT BUTTON BOTTOM RIGHT BUTTON
1Continuous* Tone Only Vibration Only
2Momentary* Tone Only Vibration Only
* Static stimulation level adjusted by Intensity Buttons (-/+).
CONTINUOUS: You control both when and how long static stimulation is delivered, up to a maximum of 10
seconds. After 10 seconds, the Remote Transmitter will “time out” and static stimulation cannot be delivered to
your dog for 5 seconds. After the 5 second “time-out” period, static stimulation can be delivered again.
MOMENTARY: Static stimulation is delivered for 1/10 of a second, regardless of how long the button is pressed.