Stagg HEADBANGERXT SLI MHW HBXT User manual

!
User Manual
HEADBANGERXT
SLI MHW HBXT

!
!
2

!
!
3
Table of Contents
1.BEFORE USAGE
This package contains
Unpacking
Introduction
Specifications
Features
2.INSTALLATION
Installation requirements
Power Connection
DMX Serial Data Link
3. OPERATION
Menu Map
Operating Instructions
DMX Channels

!
!
4
1. BEFORE USAGE
This package contains
•1x HeadBanger XT
•1x Power Cable
•1x User Manual
Unpacking
•Thank you for purchasing this product, it has been thoroughly tested
and has been shipped in perfect operating condition.
•Carefully check the packaging for damage that may have occurred during
shipping.
•If the packaging appears to be damaged, carefully inspect your fixture
for any damage and be sure all equipment necessary to operate the unit has
arrived intact.
•If damage has been found or parts are missing, please contact your vendor
or our customer support number for further instructions.
Introduction
•This fixture can operate in five different operating modes: DMX control, sound
active, automatic, manual setup or in a Master/Slave configuration
•This product comes with several built-in programs that can be used while
operating as a single unit or with multiple units linked in a master/slave
configuration
•For best results use fog or special effects smoke to enhance the beam
projection
•Warning! To prevent or reduce the risk of electrical shock or fire, do not
expose this unit to rain or moisture.
•Warning! This product may cause severe eye damage. Avoid looking directly
into the light source at all times!

!
!
5
Specifications
•Voltage: AC100V～240V, 50-60Hz
•Power Consumption: 80W
•Light source: 7x 10W RGBW 4in 1LED
•Beam angle: 25°
•Max output @1m: 6100 Lux
•PAN 540°, Tilt 220° with 16bit control
•DMX channels: 9or 12 DMX Channels
•Packing Dimensions: 275x230x255mm
•Net weight: 2,75 Kg
Features
•3PIN XLR DMX in and out
•IEC power in
•Full manual setup from the display, can be set at static
angle/color/intensity/etc…
•Dimmer for Automatic and Sound programs
•User-adjustable Pan/Tilt limiter limits the movement just to your audience
•5 Control Modes: Master/Slave, DMX, Automatic, Sound, Manual Setup
•LCD display for easy setup
•Indoor operation temperature range: -20°C～+40°C
•Dimmer: 0-100%
•Strobe 0-10Hz
Please Note: Specifications and improvements in the design of this unit and this
manual are subject to change without any prior written notice.
2. INSTALLATION
Installation requirements
•The product can be hung or placed on a solid surface
•If you install the light in a hanging position, always use a suitable
mounting position and a clamp or screw that is strong enough to hold the
product without stress. Always use a safety wire to secure the light.
•Always keep a distance of minimum 0.5m to all objects or persons
•Installation should always be done by a trained professional.
•Make sure the light always has good ventilation
•It is recommended to always use 110 Ohm DMX cable to prevent data
corruption of your DMX control signal