Stelpro sPdH User manual
INSSPDH0414
USER’S GUIDE
SPDH SERIES
SMALL PATIO DOOR HEATER
REPLACEMENT COMPONENT LIST INCLUDED
S
Y
S
T
È
M
E
Q
U
A
L
I
T
É
C
E
R
T
I
F
I
É
-
R
E
G
I
S
T
E
R
E
D
Q
U
A
L
I
T
Y
S
Y
S
T
E
M
This unit
complies with
the CSA and
UL standards
For further information or to consult this guide online, please visit our website at www.stelpro.com
INSSPDH0414
2
Before installing and operating this product, the user and/or installer must read, understand and follow these instructions and keep them handy for future refer-
ence. If these instructions are not followed, the warranty will be considered null and void and the manufacturer deems no further responsibility for this product.
, according to the
effective in your region.
The following instructions must be adhered to in order to avoid personal injuries or property damages, serious injuries and potentially fatal electric shocks.
Protect the heating unit with the appropriate circuit breaker or fuse, in accordance with the nameplate.
Make sure the line voltage (volt) is consistent with that indicated on the unit’s nameplate.
This unit must be .
Switch off the power at the circuit breaker/fuse before installing, repairing and cleaning the unit.
Make sure the unit is appropriate for the intended use (if needed, refer to the product catalog or a representative).
It corresponds to
required capacity to heat a room. If needed, refer to a specialist (industrial and commercial buildings) who will be able to calculate these heat losses and
optimize the required capacity or consult the “Online heating calculation” section of the Stelpro Design Web site (residential buildings).
Do not install the unit where objects or pieces of furniture could be heat damaged.
indicated in the installation section.
When cutting or drilling into a wall, do not damage electrical wiring and other hidden utilities.
Because this unit is hot when in use, it may pose risks even in normal operation. Therefore, be and when using it. To avoid burns, do
not let bare skin touch hot surfaces. The unit must cool down for few minutes since it will stay warm for some time after shut-down. If provided, use handles
when moving this heater.
This unit must be installed at least from objects or pieces of furniture such as, but not limited to, pillows, blankets, towels, beds,
so make sure those near the unit can withstand heat.
Do not install on a wall behind a door.
may become blocked.
products.
Some areas are dustier than others. Thus, it is the user’s responsibility to evaluate if the unit based on the amount of dirt accumulated
-
tained in accordance with these instructions.
The thermal protection activation indicates that the unit has been subjected to abnormal operating conditions. If the thermal protection remains activated or
damaged. (Refer to the limited warranty)
SAVE THESE INSTRUCTIONS
WARNING
instances, the instruction manual may not entirely match all the functions of the actual product. Therefore, the actual product and packaging, as well as the name
and illustration, may differ from the manual.
IMPORTANT INSTRUCTIONS
INSSPDH0414
3
SPECIFICATIONS
TYPE WATTS MM IN. KG LB
SPDH603 300 600 23 5/8 2.7 6
SPDH904 450 900 35 7/16 3.6 8
SPDH1206 600 1200 47 1/4 4.5 10
SPDH1507 750 1500 59 1/16 5.4 12
SPDH1809 900 1800 70 7/8 6.8 15
SPDH2110 1050 2100 82 11/16 8.2 18
SPDH2412 1200 2400 94 1/2 9.5 21
SPDH2713 1350 2700 106 5/16 10.4 23
for white or for almond
1= 120 V ; 2= 240 V ; = 347 V ; 5= 480 V; 6= 600 V ; 7= 277 V ; 8= 208 V
Please consult our product catalog to know the other available options.
TECHNICALS DRAWINGS
FRONT
SIDE
3"
77mm
1"
25mm
1"
25mm
Ø7/8"
22mm
KO
1 9/16"
39mm
1 1/16"
27mm
3 1/2"
89mm6 5/16"
160mm
2 3/16"
56mm
TYP.
TOP
1 9/16"
39mm
1 1/2"
39mm
3 5/16"
84mm
7/8"
22mm
Ø
7/8"
22mm
KO
LENGTH
2 1/16"
52mm
7/8"
22mm
Ø7/8"
22mm
KO
3 1/16"
78mm
Ø3/8"
10mm
KO
Ø7/8"
22mm
KO
2"
50mm1 3/8"
35mm
Ø3/8"
10mm
KO
1 9/16"
40mm
INSTALLATION
1. Remove the cover.
2. Screw the heater onto the wall (using the existing holes in the casing).
3. Make the required connections (see paragraph hereunder).
4. Put the cover back on.
SPECIFICATIONS, TECHNICAL DRAWINGS & INSTALLATION
or below an electrical convenience receptacle.
and liquids in the vicinity of the unit. Do not install unit in contact with combustible
materials.
INSSPDH0414
4
dish soap. Do not use abrasive or chemical cleaners because they may damage
remove dust and other foreign objects from the grills. If needed, vacuum out the
dust inside the unit. Note that cigarette smoke could yellow the discharge grill
and that the best way to prevent it is to clean the unit on a regular basis.
Don’t forget to replace front grille (with the screws that were removed) if it was
removed for cleaning.
Restore the power when cleaning or lubrication work is complete.
N.B.: If you do not solve the problem after checking these points, cut off the power supply at the main electrical panel and contact our customer service (see the
“Limited warranty” section to obtain the phone numbers).
The unit does not work
Open circuit breaker or fuse
The thermal protection has been activated
Faulty connections
The unit becomes extremely hot The unit cycles under control of the thermal protection or this latter is defective
Blocked air vents
The unit cycles under control of the thermal protection (overheat
indicator) Blocked air vents
The breaker trip when the heater is turned on Faulty connections
Voltage lower than that written on the nameplate
MAINTENANCE
TROUBLESHOOTING
ELECTRICAL WIRING
OPERATION
ELECTRICAL DIAGRAM
ALIMENTATION
L2 / N
L1
GND
A
ÉLÉMENT
E
POWER SUPPLY
L2 / N
L1
GND
A
HEATING
E
ALIMENTATION
GND
L3
L1
A
ÉLÉMENT
E
L2
A
POWER SUPPLY
GND
L3
L1
A
HEATING
E
L2
A
MISE À LA TERRE
PROTECTION THERMIQUE
CONNEXION EXTÉRIEURE
G14
ÉLÉMENT
GROUND
THERMAL PROTECTION
OUTSIDE CONNECTION
G14
ELEMENT
OPERATION, MAINTENANCE & TROUBLESHOOTING
INSSPDH0414
5
1 ELEMENT SPDH6031
1 ELEMENT SPDH6032
1 ELEMENT SPDH6038
1 ELEMENT SPDH9041
1 ELEMENT SPDH9042
1 ELEMENT SPDH9048
1 ELEMENT SPDH12061
1 ELEMENT SPDH12062
1 ELEMENT SPDH12063
1 ELEMENT SPDH12068
1 ELEMENT SPDH15071
1 ELEMENT SPDH15072
1 ELEMENT SPDH15073
1 ELEMENT SPDH15076
1 ELEMENT SPDH15078
1 ELEMENT SPDH18091
1 ELEMENT SPDH18092
1 ELEMENT SPDH18093
1 ELEMENT SPDH18096
1 ELEMENT SPDH18098
1 ELEMENT SPDH21101
1 ELEMENT SPDH21102
1 ELEMENT SPDH21103
1 ELEMENT SPDH21106
1 ELEMENT SPDH21108
1 ELEMENT SPDH24121
1 ELEMENT SPDH24122
1 ELEMENT SPDH24123
1 ELEMENT SPDH24126
1 ELEMENT SPDH24128
1 ELEMENT SPDH27151
1 ELEMENT SPDH27152
1 ELEMENT SPDH27153
1 ELEMENT SPDH27156
1 ELEMENT SPDH27158
2
2 G-SPDH06W
2
2 G-SPDH09W
2
2 G-SPDH12W
2
2 G-SPDH15W
2
2 G-SPDH18W
2
2 G-SPDH21W
2
2 G-SPDH24W
2
2 G-SPDH27W
3 PROT-185
3 PROT-186
3 PROT-179
3 PROT-180
3 PROT-181
3 PROT-182
3 PROT-183
3 PROT-183
3
1
2
REPLACEMENT COMPONENT LIST
REPLACEMENT COMPONENT LIST
INSSPDH0414
6
STELPRO DESIGN INC. | Saint-Bruno-de-Montarville | Québec | J3V 6L7
This limited warranty is offered by Stelpro Design inc. (“Stelpro”) and applies to the following product made by Stelpro: model SPDH.
, Stelpro warrants its products and their components against
defects in workmanship and/or materials for the following periods from the date of purchase:. This warranty applies only to the
; it is non-transferable and cannot be extended.
If at any time during the warranty period the unit becomes defective, you must cut off the power supply at the main electrical panel and contact 1) your
installer or distributor, 2) your service center or 3) Stelpro’s customer service department. In all cases, you must have a and
provide the . Stelpro reserves the right to examine or to ask one of its representatives to
examine the product itself or any part of it before honoring the warranty. Stelpro reserves the right to replace the entire unit, refund its purchase price
or repair a defective part. Please note that repairs made within the warranty period must be authorized in advance in writing by Stelpro and carried out
by persons authorized by Stelpro.
(electricians and distributors - French), (electricians and distributors - English), or (con-
sumers). The authorization number must be clearly written on the parcel or it will be refused.
This warranty is exclusive and in lieu of all other representations and warranties (except of title), expressed or implied, and Stelpro expressly disclaims
Stelpro’s liability with respect to products is limited as provided above. Stelpro shall not be subject to any other obligations or liabilities whatsoever,
whether based on contract, tort or other theories of law, with respect to goods or services furnished by it, or any undertakings, acts or omissions relat-
ing thereto. Without limiting the generality of the foregoing, Stelpro expressly disclaims any liability for property or personal injury damages, penalties,
-
disclaims all consequential, incidental and contingent damages whatsoever.
This warranty does not cover any damages or failures resulting from: 1) a faulty installation or improper storage; 2) an abusive or abnormal use, lack of
maintenance, improper maintenance (other than that prescribed by Stelpro) or a use other than that for which the unit was designed; 3) a natural disas-
water damages, etc. This warranty does not cover any accidental or intentional losses or damages nor does it cover damages caused by negligence
of the user or owner of the product. Moreover, it does not cover the cost of disconnection, transport, and installation.
The warranty is limited to the repair or the replacement of the unit or the refund of its purchase price,
replaced or repaired within the warranty period with the written authorization of Stelpro will be warranted for the remainder of the original warranty
period. This warranty will be considered null and void and Stelpro will have the right to refuse any claims if without
corrosion or discoloration caused by excessive heat, chemical cleaning products and abrasive agents. It does not cover any damage that occurred
during the shipping.
Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages and some of them do not allow limitations
may have other rights which vary from state to state or from province to province.
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY LIMITED WARRANTY
LIMITED WARRANTY
STELPRO DESIGN INC. | Saint-Bruno-de-Montarville | Québec | J3V 6L7
This manual suits for next models
9
Table of contents
Other Stelpro Patio Heater manuals
Popular Patio Heater manuals by other brands
Hortus
Hortus ZHQ2090-S-ADC-RMLED instructions
Silverline
Silverline COMFORT C-Wave 900 IPX4 manual
Sonnenkonig
Sonnenkonig WARMEPILZ LOUNGE user manual
Blumfeldt
Blumfeldt Cosmic Beam Series instruction manual
Blue Sky Outdoor Living
Blue Sky Outdoor Living PFP1513-CB owner's manual
Sunred
Sunred GS17K instruction manual
