Stratasys RK1600 WJ User manual

RK1600 WJ

Objet1000 Water Jet –Major Specifications
•Objet1000 Water Jet –RK1600 made by “KRUMM” Germany
•Size: 205+-5 X 205+-5 X 190 cm
•Weight: 680kg
•Ability to clean models in size of: 103.5 X 93 X 90 cm
•Input voltage 220V-240V 50Hz.
•For other input voltages or frequencies power converter is needed
•All electrical malfunctions should be handled by local authorized electricial

System Description front and upper look

Back side

Model Cleaning
1. Open the cleaning unit doors
2. Align the build tray cart with the front of the cleaning unit
3. Align the cart with the cleaning unit
4. Adjust the cart height until it locks into place on the cleaning unit.
5. The build tray can now be rolled into and out of the cleaning unit.
6. Apply the brake of the tray cart

Inserting and Removing the build tray

7. Insert the tray
8. Insert the hands into the openings and press the water gun

WJ installation
1. The unpacking and the placing of the WJ should be done by professional movers and it
is customer’s responsibility
2. In order to place the WJ on it designated place supplied in the start up kit wheels can
be used

Suggested WJ room layout.

Plumbing and GND connections
Before shipment, the cleaning unit is tested and the pump drain plug is
removed, to allow the internal parts of the pump to dry.
If this plug is not installed before connecting the water supply, intake water
will immediately leak from the pump, and flood the area.
Install the threaded plug and washer as shown below.