Stratco CORRUGATED GARDEN BED KIT User manual

RAISED GARDEN BED INSTALLATION GUIDE
RAISED GARDEN BED
INSTALLATION GUIDE
INSTALLATION GUIDE
STRATCO CORRUGATED
GARDEN BED KIT
TOOLS REQUIRED
Phillips Head Screwdriver Pliers Safety Gloves Safety Glasses
BEFORE YOU START
Prior to installation, choose a suitable location on flat ground for your Stratco Corrugated Garden Bed. Measure the area to
ensure there is enough room. A minimum area of 40” x 28” is required.
To ensure the installation of your Garden Bed proceeds smoothly you should confirm that all components listed in this
installation guide have been supplied. Carefully read this installation guide to familiarise yourself with the steps involved, and
ensure that you have the correct tools and equipment for the job.
NOTE: Use heavy gloves when handling steel sheeting and do not attempt installation in windy conditions.

All brands and logos/images accompanied by ® or ™ are trade marks of Stratco (Australia) Pty Limited. ® Copyright December 2018
[phone]
stratcousa.com
Wingnuts and
Screws
x 32
Long Panel
x 2
Corner Angle
x 4
Short Panel
x 2
COMPONENTS
Screws
Wing Nuts
STEP 2
STEP 3
STEP 4
ASSEMBLY
Note: Ensure Wingnuts are located on inside
Repeat Steps 1 & 2 for two sides
Note: Ensure Wingnuts are located on inside
STEP 1
Note: Ensure safety edge on both panel and corner faces
toward inside of garden bed. The corner piece may need to
be flipped top to bottom to fit into the corrugations of the
panel.