Stratco LG-40803 User manual

RAISED GARDEN BED - DOUBLE HEIGHT INSTALLATION GUIDE
RAISED GARDEN BED - DOUBLE HEIGHT
INSTALLATION GUIDE
BEFORE YOU START
Prior to installation, choose a suitable location on flat ground for your Garden Bed, a minimum 118cm x 92cm is required.
To ensure the installation of your Stratco Garden Bed proceeds smoothly you should confirm that all the components listed in
this installation guide have been supplied.
Carefully read this installation guide to familiarise yourself with all the steps involved, and ensure that you have the correct
tools and equipment for the job. All required tools are available for purchase at your local Stratco store.
Use heavy gloves when handling steel sheets and parts. Never attempt to assemble the garden bed in windy conditions.
Corner Cap
x8
Corner
x8
COMPONENTS
Bolt & Wing Nut
x56
Panel
x4 - 840mm
x4 -1100mm
Pliers
Gloves
TOOLS
Phillips-head Screwdriver
Safety Glasses
SAFETY GEAR

PM-11533
«SCAN THIS QR CODE TO FIND A STRATCO NEAR YOU
1300 155 155
stratco.com.au
All brands and logos/images accompanied by ® or ™ are trade marks of Stratco (Australia) Pty Limited. ® Copyright January 2020
ASSEMBLY - STEP 1
Assemble the two short sides of the Raised Garden Bed as illustrated
below. Firstly, lap two 840mm panels over each other, then two Corner
pieces. Fasten one Bolt and Wing Nut through the middle holes of the
Corner pieces and Panels. Fasten Bolts and Wing Nuts through the
remaining holes. Complete these steps for both ends of the Panel.
ASSEMBLY - STEP 2
Fasten the 1100mm Panels to the Panels
assembled in step 1.
1100mm Panel
Corner
840mm Panel
Fasten middle Bolt first,
then remaining Bolts.
Corner Cap
Ensure the top Panel is lapped
over the bottom Panel.