Stratco Metal Elevated Garden Bed User manual

METAL ELEVATED GARDEN BED INSTALLATION GUIDE
STRATCO METAL ELEVATED GARDEN BED
INSTALLATION GUIDE
Corner Cap
x4
Corner
x4
COMPONENTS
Panel
x2 - 10” x2 - 31”
Pliers
Gloves
TOOLS
Phillips-head Screwdriver
Safety Glasses
SAFETY GEAR
Base
x1
BEFORE YOU START
Prior to installation, choose a suitable location on flat ground for your Garden Bed, a minimum 33.5” x 12.5” is required. To
ensure the installation of your Garden Bed proceeds smoothly you should confirm that all the components listed in this
installation guide have been supplied.
Carefully read this installation guide to familiarise yourself with all the steps involved, and ensure that you have the correct
tools and equipment for the job. All required tools are available for purchase at your local hardware store.
Use heavy gloves when handling steel sheets and parts. Never attempt to assemble the Garden Bed in windy conditions.
Bolt & Wing Nut
x24 short
x8 long

«SCAN THIS QR CODE TO FIND A STRATCO NEAR YOU
[phone]
stratcousa.com
All brands and logos/images accompanied by ® or ™ are trade marks of Stratco (Australia) Pty Limited. ® Copyright April 2020
Corner
31” Panel
Corner Cap
Base
Loosely fasten bolts.
Use long bolts when
fastening to the base
for ease of assembly.
ASSEMBLY - STEP 1
Assemble the two long sides of the Garden Bed
as illustrated. Firstly, assemble the Panel, Corner
and Corner Cap together. Then assemble the
Panel, Corner and Base together using the long
bolts provided.
Loosely fasten the Bolts and Wing Nuts to ensure
all parts fit together easily. Complete these steps
for both ends of the Panel.
ASSEMBLY - STEP 2
Fasten the two short Panels to the Corner and Base
assembled in step 1. Once all Panels are assembled,
tighten all the Bolts.
10” Panel
Loosely fasten bolts.
Use long bolts when
fastening to the base
for ease of assembly.