Stratco MODULAR GARDEN BED LG-34498 User manual

48” X36” WOOD-PLASTIC COMPOSITE GARDEN BED
MODULAR GARDEN BED®
INSTALL GUIDE
PRIOR TO ASSEMBLY
If you are installing a custom garden bed designs, please confirm you have all
the extra pieces you need for the design.Carefully read this installation guide
to familiarise yourself with all the steps involved before beginning installation.
LOCATION SELECTION
Choose a suitable location for the garden bed’s installation. Measure the area
to ensure there is at least 48” x 36” of space. If you have purchased extra
kits and plan to create a custom design, please ensure you measure the full
space required for your garden bed design. Make sure the location is on flat
and level ground.
IMPORTANT NOTES
1. The garden bed will be difficult to move after assembly. Please choose your
location carefully before beginning assembly
BEFORE YOU START
Long Plank
x 4
Short Plank
x 4
Post Cap
x 4
Corner Post
x 4
COMPONENTS
To ensure the installation of your Stratco Garden Bed proceeds smoothly
you should confirm that all the components listed in this installation guide
have been supplied.
FORM: GB – 2777

stratcousa.com
Ph: [phone]
ASSEMBLY
Figure 3
Figure 4
Long Planks
Long Planks
Figure 2
Short Planks
Short Planks
Figure 1
Slide the short planks into the corner posts to form the two ends of the
garden bed as shown below (Figure 1).
Place the two short ends in position where the garden bed will be installed.
After this step it will be difficult to move the garden bed so ensure the bed is
in the desired position . Slide the long planks into the corner posts as shown
below (Figure 2).
Insert the four caps into the top of the corner posts as shown (Figure 3). If
you have purchased extra Garden Bed kits to create a custom design, install
extra planks and posts before inserting the caps.
Your Stratco Modular Garden Bed is now assembled (Figure 4). Move the
garden bed into position before filling with soil. A single Stratco Modular
garden bed will hold approximately 10 cu. ft. of soil.
© 2018
FORM: GB – 2777 FILE CREATED 21/05/2018