Subaru H621SFG500 User manual

DESCRIPTION:
iPod integration kit
PART N
UMBER:
H621SF 500
KIT CONTENTS:
A
Mounting bracket 1x iPod interface 1x
iPod dock cable 1x
B
C
D
E
F
H
I
K
J
Cable tie 4x Bus cable 1x Plastic clip 2x
Console bin grommet 1x User guide 1x Quick reference
guide 1x Install manual 1x
Screw 2x
TOOLS REQUIRED:
10 mm
14 mm drill bit (9/16")
Nylon trim
removal tool
ICON LE ENDS:
PART NUMBER
H621SF 500
ISSUE
S01
DATE
06/07/07 SUBARU OF AMERICA PA E 1/5
:
Remove/Disconnect
:
Location of clip or screw

PART NUMBER
H621SF 500
ISSUE
S01
DATE
06/07/07 SUBARU OF AMERICA PA E 2/5
1
2
3
4
Note: Ignition should be off
when disconnecting negative
battery terminal.
Starting from bottom, pry
carefully along edges to
remove trim panel.
Remove 4 radio screws. Carefully disconnect wire harnesses and remove radio.
Carefully remove par ing bra e
boot. Remove console screw. Remove 2 screws from console bin.
5
6

PART NUMBER
H621SF 500
ISSUE
S
01
DATE
06/07/07 SUBARU OF AMERICA PA E
3/5
8
9
Tilt console bac . Disconnect wire harness and
remove console from vehicle.
7
Using a 14 mm (9/16 inch) drill bit,
drill a hole in console bin, about
19 mm (¾ inch) from edge.
¾”
Feed doc cable (C) through hole and place
console bin bac in vehicle in upright position as
shown in slide 7.
C
10
Pry gently around edges to remove
trim panel. Note: Gear selector must
be in “N” with par ing bra e set,
ignition off and vehicle on level
ground. For manual transmission
vehicles, shift nob must be removed
by unscrewing in a counter
cloc wise direction.
11
Route doc cable towards front of vehicle as shown. Doc cable should be routed behind HVAC
controls and up to the radio opening.

PART NUMBER
H621SF 500
ISSUE
S01
DATE
06/07/07
SUBARU OF AMERICA PA E
4/5
15
16
12 13
Connect doc cable (C) to module. Secure doc cable
to brac et leg with cable tie (D). Connect bus cable
(E) to module and route behind brac et as shown.
C
D
E
F
A
B
Attach module (B) to brac et (A) as shown. Insert
plastic clips to (F) placing from the bottom up.
14
Use screws (G) to attach
brac et/module assembly to
vehicle as shown.
G
Connect bus cable (E) to radio. Use the “Y” harness
to reconnect any factory harness occupying the bus
connector, when applicable. Reseat all other
connections removed in step 4 and reinstall radio.
E
D
Secure cable with cable ties (D). If necessary, bundle any excess cable in this area.
E

PART NUMBER
H621SF 500
ISSUE
S01
DATE
06/07/07
SUBARU OF AMERICA PA E
5/5
17 18
C
H
Lower the console bac into position. Gently
remove excess slac from doc cable (C). Secure
into console bin with grommet (H).
Reassemble vehicle by following steps 1-7,
10 in reverse.
For operation, consult User manual.