Subaru H6710SG000 User manual

1
TOOLS NEEDED
PRECAUTIONS
•Please refer to the precautions below before you begin work, in order to install the product safely and accurately.
Please also refer to the vehicle Service manual.
•This manual shows typical installation procedures on RHD vehicle. Installation will be mirror image for LHD vehicles.
ATTENTION
•
•Please disconnect the battery cable while conducting wiring operations. Failure to do
so may result in electrical shock or injury.
• When tightening bolts or screws, use the proper tools and the proper size, and comply
for the specified torque specified for the part.
Failure to securely tighten the bolt and nut may cause them to loosen and fall off,
causing damage.
•When removing the connector from the vehicle, remember to remove the lock that
holds the mainbody of the connector, instead of pulling the lead line.
This protects against a lead wire cuts, etc.
Please confirm that the electrical components of the vehicle operate normally. Also,
please make an note of data in the memory of the electrical components such as the
radio. This will help avoid problems that may arise when performing the repair check
after the installation.
EN: CIGARETTE LIGHTER
KIT Installation Instruction
PART No.
EN : COMPONENTS
No. Name Qty
①Socket ASSY 1
②Plug 1
21
FORESTER
H6710SG000

2
•
12V/120W
- Wrap the screwdriver with vinyl tape to avoid scratching the trim panels.
1. Removing assocoated parts
MOUNTING THE CIGARETTE LIGHTER (REPLACING WITH ACCESSORY SOCKET)
1. Apply parking brake firmly and shift the selector lever into N range.
BEFORE BEGINNING INSTALLATION
・Afterinstallingthewiring,performanoperationscheckonthenewlyinstalledpartsbefore
reassembling.Thishelpspreventmis-wiring.
・Be careful not to forcefully pull the wiring harness of the vehicle. This helps prevent the
connector from being disconnected, and the wires from being cut or damaged.
・When connecting or disconnecting parts or installing or removing the finisher, etc, be
careful not to let the harness be hooked or pulled from the back. This protects against
a cut wire or shorts.
•When wiring the harness(wiring), clamp the wires together along with the wiring harness of
the vehicle. This protects the harness from becoming entangled or causing strange sounds.
Please be sure to properly connect the connector and terminal. This helps to avoid a poor
connection.
2. Disconnect the battery negative cable.

1
3
2
If connector is connected to the
switch behind the cover, disconnect it.
3

Remove driver side control cable
Put protective tape Remove Pull to remove glove box
Remove passenger side control cable
For manual air-conditioner specifications
4
6
5
4

Push
Align
Pull
Remove socket
Install cigarette lighter as shown
・Re-installtheremovedparts
・Reconnectthebattery
・ShifttheselectorleverintoPfromN
7
10
9
8
Common specification for manual and automatic air-conditioner
5