Sumitomo CC-17 User manual

CC-17/ WT-17
Quick Reference guide
Jacket Remover
Fusion splicer
Fiber Cleaver
Cooling tray
Dust bin
Body pad Neck strap hole Cleaver Strap hole
2. Hook the strap in one of
the strap holes as
highlighted in red in the
above figure.
3. Place the strap around
your neck.
Tripod
You can work as soon as you open the CC-17.
1. Attach the body pad to
the tray.
Alcohol dispenser
Upper stack Waist belt
■Carryin
g
Case CC-17
How to use the CC-17/WT-17
■Workin
g
tray WT-17
■Other convenient functions

2. Pull the lever and place the
fusion splicer on the WT-17
p
ro
p
erl
y
.
1. As shown in the picture
left, install the fusion
splicer by passing the
red-lined section under
the red-circled
protrusion.
This page describes how to remove/attach the fusion splicer to WT-17.
*AS24G181
*
Sumitomo Electric Industries, Ltd. reserves the right to change the specification or design without
notice and may therefore not coincide with the contents of this quick reference guide. E&OE
For further detailed operating instructions and functions, please see Operation manual.
The Operation manual can be downloaded via
http://www.rim-plus.sei.co.jp/fsma/manual/serial
OME2024181-2 /Ver.1.00
1. While holdin
g
the fusion
splicer, pull the lever.
■How to take out the fusion splicer
2. Lift the fusion splicer
while pulling the lever.
3. Remove the fusion
splicer towards you
while
p
ullin
g
the leve
r
.
■How to attach the fusion splicer
3. Try to move the splicer after it is
locked in place to ensure it is fully
secured to the WT-17.
If the fusion splicer is not securely attached to the WT-17, it may fall.
❚How to take out/attach the fusion splicer to WT-17
Make sure the splicer is properly secured.
NG
The splicer is
shaky as it is
not locked
properly.
NG
The splicer is
lifted as it is
attached in a
wrong way.