Sunnydaze Decor GSI-274 User manual

GSI-274
Parts:
A. Basin- 1 pc
B. Pump and transformer- 1 pc
C. Lid- 1pc
D. Fountain body- 1pc
E. Clock- 1pc
F. Splash guard- 1 pc
G. Connector Bolts
H. Pebbles-1 bag
Assembly Instructions:
1. Insert the pump into the basin and connect the pump to the
hose.
2. Plug the pump cord into the transformer.
3. Connect the lid to the fountain body.
4. Connect the lid and fountain body to the basin.
5. Place the clock onto the fountain body.
6. Connect the splash guard to the middle of the lid.
7. Put the pebbles in the basin.
8. Plug the power cord into an electrical outlet.
Warning and Safety:
•The pump and light are tested and approved for indoor use
only.
•Keep fountain out of reach of children.
•Use proper power source as indicated on water pump label.
•Keep electrical cords away from all heat sources.
•Do not place electrical cords in high temperatures.
•Check water level at pump location regularly. Make sure that
the pump is fully submerged to avoid damaging the pump.

Troubleshooting:
•Pump operates but no flow: Make sure pump is fully submerged into the water. If there is still no
water, turn off the transformer and repeat this step.
•Water speed: You can adjust the speed of the water flow by using the switch control located on the
pump housing.
•Noise from the fountain: Check water level and make sure that the pump is completely submerged.
•Light does not shimmer: Check the light bulb and sure that it is fully connected to the socket.