Sunricher SR-2833T2 User manual

RF Single Color Wall Mounted Controller 09.28T2U.04212
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Zone 1
Zone 3
Zone 2
Zone 4
Click to turn on/off, press and
hold down to increase/decrease
light intensity
Back side
19.4 mm 43.58 mm
65.58 mm
DC Power input
V- V+
DC INPUT
RF Wall Panel
Controller
83.00 mm
Wiring diagram
12-24VDC
PSU
AC 100-240V
Output Signal RF signal
Power Supply 12-24VDC
Power consumption 200 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 75x120x29.1mm
• Touch sensitive
• Glass interface(white & black)
• Compatible with all universal series RF receivers, radio frequency: 916.5MHz
• Control single color
• Control 4 zones of RF receiver
• Waterproof grade: Ip20
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
V- V+
DC IN PUT
RF Wa ll Panel
Cont ro ller
DC Version
RF Wall Panel
Controller
AC Version
L NL N
AC INPUT
AC Power input
RF signal
100-240VAC
15 mA
0-40°C
8% to 80%
75x120x29.1mm
DC Version AC Version
DC Version
AC 100-240V
AC Version
RF Wa ll Panel
Cont ro ller
AC Version
L NL N
AC IN PUT
AC Power
50/60Hz
AC Power
50/60Hz

Installation
Pair with RF receiver
Step 2:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 1:Do wiring the wall panel & RF receiver according to wiring diagram
(please refer to the instruction of RF receiver that you would like to pair with)
Step 3:Choose one zone and touch button of the zone(e.g. zone 4),
LED lights connected with the RF receiver flicker once means the receiver is
paired with zone 4 successfully.