superbrightleds DDAL K Series User manual

Dusk-to-Dawn Area Light
WIFI-CON
User Manual
Important: Read all instructions prior to installation. DDAL-xKx-xBRS
Parts Included
Specications
Photocell Operation
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
- Dusk-to-Dawn Area Light
- Pole Mount Bracket
- Wall Mount Bracket
- Hardware Kit
DDAL-40K35-LBRS
Model DDAL-xK35-xBRS DDAL-xK70-xBRS
Input Voltage 120–277 VAC
Input Power 35 W 70 W
Input Current 0.29 A (292 mA) @120 VAC 0.58 A (583 mA) @120 VAC
Environmental Rating IP64
Operating Temperature -40°–122° F (-40°–50° C)
• Product should be installed by a certied electrician in
accordance with applicable national, state, and local
building and electrical codes.
• To reduce the risk of electric shock, ensure that the main
power source and circuit breakers are switched o󰀨 before
performing any installation or wiring procedures.
• Avoid looking directly into the lamp when illuminated.
• Ensure all mounts are securely attached and will support
the weight of the xture. Failure to properly support
the xture may result in damage or injury, for which the
manufacturer does not assume responsibility.
• Burn Hazard—do not touch light housing when light is on.
Allow housing to cool before handling.
Safety and Notes
Wall Mount Installation¹
Preinstalled photocell sensor switches light on when ambient light is
below 10–20 lx, and o󰀨 when ambient light goes back above 25–35 lx.
1. Measure mounting ange and drill three 5/32” pilot holes.
2. Partially thread the bottom two lag screws in place.
3. Make all electrical connections. Wire should pass through
bottom or rear conduit bracket knockout using an appropriate
strain relief (not included).
4. Attach conduit bracket to light.
5. Place light over to lower lag screws and install third lag screw,
then tighten all lag screws.
¹DDAL-xKx-LBRS shown, DDAL-xKx-SBRS mounts similarly
2.87in
72.87mm
11.00in
279.40mm
6.25in
158.75mm
4.88in
124.03mm
POWER WIRE
3.51in
89.15mm
12.60in
320.04mm
2.50in
63.50mm
.86in
21.84mm
.25in
6.25mm
2.70in
68.45mm
2.28in
57.99mm
PHOTOCELL
SENSOR
CONDUIT KNOCKOUT
Wall Mount Conduit Bracket
Pole Mount Bracket
1.75in
44.45mm
5yr

Dusk-to-Dawn Area Light
WIFI-CON
User Manual
Important: Read all instructions prior to installation. DDAL-xKx-xBRS
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Pole Mount Installation¹
1. Make all electrical connections.
2. Losely attach pole mount bracket to light.
3. Slide light over pole (max diameter 1.75” OD) and tighten mount bracket.
Note: Overtightening bracket may result in damage to pole.
¹DDAL-xKx-LBRS shown, DDAL-xKx-SBRS mounts similarly
5yr