suprema XPass D2 User manual

2021/03/01 06:25 / How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
Table of Contents
How to Configure D2 Keypad 1 ..............................................................................................................
Adding as a Slave Device 1 ................................................................................................................
Using the device as a Wiegand Reader 2 ...........................................................................................

2021/03/01 06:25 1/3 How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
System Configuration, BioStar 2, “D2, Keypad”
How to Configure D2 Keypad
Xpass D2 Keypad is a new device introduced with BioStar 2.6.2.
It is a dummy reader for reading cards or PIN, which means it doesn’t perform data matching on the
device.
The device can be used as slave device, or a Wiegand reader to send Wiegand output.
The device sends out a Wiegand signal with the default 26bit format and the Wiegand configuration
will be done with a separate tool.
Adding as a Slave Device
You will need a master device to add the slave D2 Keyapd device.
Refer to the article below to learn how to search a slave device.
RS485 Mode (Master, Default, Slave)
If you enable the option 'Input card ID from keypad', user can authenticate by entering the card
number on the D2 Keypad.

2021/03/01 06:25 2/3 How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
Possible key input ranges
The range of numbers that can be received by the keypad is 8 bytes (0 to
18,446,744,073,709,551,615)
Using the device as a Wiegand Reader
If you have already used the device as a slave device before, you must reset the device to use it as a
Wiegand reader (sending Wiegand output).
1. Delete the device from BioStar 2 client as a slave device.
2. Detach the metal bracket from the device.
3. Press the reset button.
4. Use the device as a Wiegand reader by adding it as a Wiegand Device on a master device.

2021/03/01 06:25 3/3 How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
You cannot use the device as a slave device and use Wiegand output at the same time.
From:
https://kb.supremainc.com/knowledge/ -
Permanent link:
https://kb.supremainc.com/knowledge/doku.php?id=en:how_to_configure_d2_keypad
Last update: 2019/02/26 22:36