Symmons TA-10 User manual

Replacing a TA-10 Spindle
1) First, you need to make sure the water to the valve has been shut o. Then, we need to
open the valve to the warm/hot posion. Ulizing your handle, rotate counter-clockwise un-
l the handle stops.
2) Using a wrench, rotate the cap assembly (T-12A) counter-clockwise unl the cap (T-12A)
and spindle assembly (TA-10) are removable from the valve body.

3) Noce how the TA-10 spindle rests up against the T-12A cap. This is assurance that the
valve was open fully to the hot water posion before trying to remove the cap. Failure to do
so can damage the cap and spindle and make it extremely dicult to remove the spindle
from the valve. Rotang the spindle counter clockwise, remove the spindle from the cap as-
sembly.
4) Take the new Spindle (TA-10) and insert into the cap assembly (T-12A). Thread the new
spindle (TA-10) all the way into the cap clockwise unl it rests at against the spindle.

5) Take your assembled cap assembly (T-12A) and spindle (TA-10) and insert the cartridge
back into the valve. Using a wrench, ghten the cap assembly (T-12A) back to the body of
the valve in a clockwise rotaon. Close the valve body ulizing your handle and rotang
clockwise unl the valve closes. Restore the water supply back to the valve and check for
leaks.